Микроволновые печи Sharp R-247E - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
E – 3
A35662,Russia R247E O/M,EN
8
10
2
7
6
5
4
3
1
4
11
9
12
14
13
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity . Check the unit for any damage, such as a
misaligned door, damaged gaskets around the door or dents inside the oven cavity or on the door.
If there is any damage, please do not operate the oven until it has been checked by a SERVICE CENTRE
APPROVED BY SHARP and repaired, if necessary.
2. Accessories provided
1)
Turntable tray
2)
Roller stay
3)
Operation manual and cooking guide
4)
Cook book (Russian)
3. Locate the roller stay in the centre of the oven, then fit the turntable on the roller stay. Make sure the
turntable and roller stay are centrally located and locked together. NEVER OPERATE THE OVEN
WITHOUT THE ROLLER STAY AND TURNTABLE.
4. The oven should not be installed in any area where excessive heat and steam are generated, for
example, next to a conventional oven unit. The oven should be installed so as not to block ventilation
openings.
Allow at least 15 cm on the top of the oven for free air space.
5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or
personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 220V, 50Hz.
OVEN DIAGRAM
8. Control panel (See page E-4)
9. Digital readout
10. Waveguide cover
11. Turntable
12. Roller stay
13. Ventilation openings
14. Power supply cord
1. Door handle
2. Oven lamp
3. Door hinges
4. Door safety latches
5. See through door
6. Door seals and sealing surfaces
7. Coupling
Untitled-2
03.10.23, 3:00 PM
3
