VITEK VT-6405 - Инструкция по эксплуатации - Страница 6

    English

6

light, rain or snow does not get it. 
House mechanisms (door bell, signal 
system etc.) can cause interferences 
while reception by the base unit of 
data signals from the remote sensor. 
It is normal and does not influence the 
general operation. Transfer and re-
ception of the data signal will resume 
immediately after the temporary inter-
ferences disappear. 

Placing batteries in the remote 
sensor

1.  Unscrew the screws on the 

battery compartment lid.

.  Select data transfer channel 

using the channel switch.

.  Set  batteries, following the 

polarity.

.  Close the battery compartment 

lid and tighten up the screws.

Connecting the net adapter to the 
base unit/placing batteries into 
the base unit

1.  Open the battery compartment 

lid.

.  Set  batteries (“ААА”, 1.5 V), 

following the polarity.

.  Close the battery compartment 

lid and tighten up the screws 

.  Make sure that the adapter 

voltage corresponds to the 
voltage in the mains. 

5.  Using the external power supply 

jack, connect the net adapter to 
the base unit supplied (7,5 

V DC)

.

Note: 

The base unit is intended to be pow-

ered by the external power supply; 
battery supply is a backup variant. 

If the net adapter is disconnected 
from the base unit, the following sym-
bol will appear on the display ( )

Battery replacement

When the corresponding indication 
about battery discharge appears you 
should replace the batteries. 

Note: While long operation of the 
remote sensor at high or low tempera-
tures, its voltage can lower, reducing 
thus the operating radius of its trans-
mitter.  

STARTING OPERATION

After inserting of the batteries in the 
remote control, it will start data trans-
fer (temperature and humidity) with 
about 5 second intervals. In about 
two minutes after inserting of the 
batteries in the base unit or connect-
ing to the mains, it will start in its turn 
searching of a signal from the remote 
control. In ten minutes after receiving 
data, they will appear on the display of 
the base unit. Data updating is per-
formed automatically in 5 seconds.  

If there is no signal from the remote 
sensor, the “--“symbols will appear on 
the display.
For synchronization of the base unit 
and the remote sensor press and 
hold the 

▼

/SEARCH button during  

seconds.

Note: Repeat this procedure, if the 
registrations of the remote sensor dif-
fer from those of the base unit. 

6405IM.indd   6

12.11.2008   11:21:13