GIGABYTE H47 - Инструкция по эксплуатации - Страница 23

- 23 -

13)  CLR_CMOS (Clear CMOS Jumper) 

Use this jumper to clear the BIOS configuration and reset the CMOS values to factory defaults. To clear 

the CMOS values, use a metal object like a screwdriver to touch the two pins for a few seconds.

14)  BAT (Battery)

The battery provides power to keep the values (such as BIOS configurations, date, and time information) 

in the CMOS when the computer is turned off. Replace the battery when the battery voltage drops to a low 

level, or the CMOS values may not be accurate or may be lost.

•

Always turn off your computer and unplug the power cord from the power outlet before clearing 

the CMOS values.

•

After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or 

manually configure the BIOS settings (please navigate to the "BIOS Setup" page of GIGABYTE's 

website for more information).

Open: Normal

Short: Clear CMOS Values

You may clear the CMOS values by removing the battery:

1.  Turn off your computer and unplug the power cord.

2.  Gently remove the battery from the battery holder and wait for one 

minute. (Or use a metal object like a screwdriver to touch the positive 

and negative terminals of the battery holder, making them short for 

5 seconds.) 

3.  Replace the battery.

4.  Plug in the power cord and restart your computer.

•

Always turn off your computer and unplug the power cord before replacing the battery.

•

Replace the battery with an equivalent one. Damage to your devices may occur if the battery is 

replaced with an incorrect model.

•

Contact the place of purchase or local dealer if you are not able to replace the battery by yourself 

or uncertain about the battery model.

•

When installing the battery, note the orientation of the positive side (+) and the negative side (-) 

of the battery (the positive side should face up).

•

Used batteries must be handled in accordance with local environmental regulations.