GIGABYTE GA P67A UD4 rev 1 1 - Инструкция по эксплуатации - Страница 19

- 19 -

Hardware Installation

1-6  Setting up ATI CrossFireX

™

/NVIDIA SLI Configuration

A. System Requirements

   -  Windows 7, Windows Vista or Windows XP operating system
   -  A CrossFireX/SLI-supported motherboard with two PCI Express x16 slots and correct driver
   -  Two CrossFireX/SLI-ready graphics cards of identical brand and chip and correct driver
   -  One CrossFire 

(Note)

/SLI bridge connector

   -  A power supply with sufficient power is recommended (Refer to the manual of your graphics cards for   

   the power requirement)

B. Connecting the Graphics Cards

Step 1:
Observe the steps in "1-5 Installing an Expansion Card" and install two CrossFireX/SLI graphics cards on the 
PCI Express x16 slots.
Step 2:
Insert the CrossFire 

(Note)

/SLI bridge connector in the CrossFireX/SLI gold edge connectors on top of the two 

cards.
Step 3:
Plug the display cable into the graphics card on the PCIEX16 slot.

C. Configuring the Graphics Card Driver

C-1. To Enable CrossFireX Function

After installing the graphics card driver in the operating system, go to 

the 

Catalyst  Control  Center

.  Browse  to  the 

CrossFireX

  menu  and 

ensure the 

Enable CrossFireX

™

check box is selected.

Procedure and driver screen for enabling CrossFireX/SLI technology may differ by graphics cards. 

Refer to the manual that came with your graphics cards for more information about enabling Cross-

FireX/SLI technology.

C-2. To Enable SLI Function

After  installing  the  graphics  card  driver  in  the  operating  system,  go 
to  the 

NVIDIA  Control  Panel

.  Browse  to  the 

Set  SLI  and  Physx 

Configuration

  screen  and  ensure 

Maximize  3D  performance

  is 

enabled.

(Note)  The bridge connector may be needed or not depending on your graphics cards.