GIGABYTE 8VT800 RZC - Инструкция по эксплуатации - Страница 35

- 35 -

BIOS Setup

English

Set Supervisor/User Password

When you select this function, the following message will appear at the center of the screen to assist you
in creating a password.
Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the password.
Type the password again and press <Enter>. You may also press <Esc> to abort the selection and not
enter a password.
To disable password, just press <Enter> when you are prompted to enter password. A message
"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is
disabled, the system will boot and you can enter Setup freely.
The BIOS Setup program allows you to specify two separate passwords:
SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access all BIOS
Setup program function. When enabled, the Supervisor password is required for entering the BIOS
Setup program and having full configuration fields, the User password is required to access only basic
i t e m s .
If you select "System" at "Password Check" in Advance BIOS Features Menu, you will be prompted
for the password every time the system is rebooted or any time you try to enter Setup Menu.
If you select "Setup" at "Password Check" in Advance BIOS Features Menu, you will be prompted only
when you try to enter Setup.

CMOS Setup Utility-Copyright (C) 1984-2004 Award Software

}

Standard CMOS Features

}

Advanced BIOS Features

}

Integrated Peripherals

}

Power Management Setup

}

PnP/PCI Configurations

}

PC Health Status

}

Frequency/Voltage Control

Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving

ESC: Quit

higf

: Select Item

F8: Q-Flash

F10: Save & Exit Setup

Change/Set/Disable Password

Enter Password: