JVC KD-BT1 - Инструкция по эксплуатации - Страница 46

ENGLISH

46

Troubleshooting

What appears to be trouble is not always serious. Check the following points before calling a service center.

Symptom

Remedy/Cause

General

•  Sound cannot be heard from the speakers.

•  Adjust the volume to the optimum level.
•  Check the cords and connections.

•  The unit does not work at all.

Reset the unit (see page 3).

•  “Connect Error” appears on the display.

Remove the control panel, wipe the connector, then attach 
it again (see page 4).

FM/AM

•  SSM automatic presetting does not work.

Store stations manually.

•  Static noise while listening to the radio.

Connect the aerial firmly.

Discs in general

•  Disc cannot be played back.

Insert the disc correctly.

•  CD-R/CD-RW cannot be played back.
•  Tracks on the CD-R/CD-RW cannot be skipped.

•  Insert a finalized CD-R/CD-RW.
•  Finalize the CD-R/CD-RW with the component which you 

used for recording.

•  Disc can neither be played back nor ejected.

•  Unlock the disc (see page 14).
•  Eject the disc forcibly (see page 3).

•  Disc cannot be recognized (“No Disc,” “Loading 

Error,” or “Eject Error” flashes).

Eject the disc forcibly (see page 3).

•  Disc sound is sometimes interrupted.

•  Stop playback while driving on rough roads.
•  Change the disc.
•  Check the cords and connections.

•  “Please Eject” appears on the display.

This occurs sometimes due to over-heating. Eject the disc 
or change to another playback source.

MP3/WMA/AAC

•  Disc cannot be played back.

•  Use a disc with MP3/WMA/AAC tracks recorded in the 

format compliant with ISO 9660 Level 1, Level 2, Romeo, 
or Joliet.

•  Add the extension code <.mp3>, <.wma>, <.m4a> to 

the file names.

•  Noise is generated.

Skip to another track or change the disc. (Do not add 
the extension code <.mp3>, <.wma>, or <.m4a> to 
non-MP3/WMA/AAC tracks.)

•  If “LCD Type” is set to “Auto,” the display pattern 

will change to the “Positive” or “Negative” pattern 
depending on the “Dimmer” setting.

•  If you change the “Amp Gain” setting from 

“High PWR” to “Low PWR” while the volume level is 
set higher than “Volume 30,” the unit automatically 
changes the volume level to “Volume 30.”

  General settings—PSM 

•  “Auto” setting for “Dimmer” may not work correctly 

on some vehicles, particularly on those having a 
control dial for dimming. 

  In this case, change the “Dimmer” setting to any 

other than “Auto.”