Hyundai Electronics H-CMD4031 - Инструкция по эксплуатации - Страница 12

12

13

Operation

Operation

VOL- buttons on the RC or rotate VOLUME 
regulator on the panel to select between BEEP 
ON (beep sound will be heard when buttons 
are pressed) and BEEP OFF. After you have 
reached your desired effect, leave the unit idle 
in order for the new setting to take effect.

Button backlight color

Press repeatedly SELECT button on the 

panel or SEL button on the RC until the display 
shows COLOR1 (COLOR2). Press VOL+/VOL- 
buttons on the RC or rotate VOLUME regulator 
on the panel to select between COLOR1 
(green button backlight) and COLOR2 (red 
button backlight). After you have reached your 
desired effect, leave the unit idle in order for 
the new setting to take effect.

TFT on/off

Press POWER/TFT OFF button on the panel 

to switch the TFT display off. Press the button 
again to switch the display on.

AUX in jack

AUX-in jack is intended for connecting 

external audio equipment to amplify the 
sound. If connection is made correctly, the 
audio signal from the external source will be 
translated through the acoustics of the head 
unit. This enables to adjust the volume and 
quality of the sounding. For example, you can 
connect an MP3-player to listen to tracks using 
the car acoustic system.

Radio operations

Band select

Press repeatedly BND/NP button on the 

panel or BAND button on the RC to select your 
desired radio band in Radio mode: FM1, FM2, 
FM3, AM1 (MW1), AM2 (MW2). In each set of 
the bands you can store up to 6 preset stations, 
making total 30 preset memory stations.

Auto/Manual tuning

•  Manual tuning: Press PREVIOUS/NEXT 

buttons on the panel or on the RC to manually 
adjust the radio frequency.

•  Auto tuning: Press and hold PREVIOUS/

NEXT buttons on the panel or on the RC, the 
radio will seek to the next up or down strong 
and clear frequency station automatically. 
Repeat this action to seek for other desired 
stations. To stop automatic search, press NEXT 
or PREVIOUS button on the panel or on the RC.

Programming tuner stations

There are six numbered preset buttons, 

under which you can store and recall stations 
for each band. Select the needed frequency, 
then press and hold a preset button. The 
station will be saved in the memory under 
the corresponding number. To recall a stored 
station, press the corresponding preset button.

Automatic store/preset scan

•  Automatic store: Press and hold AUDIO 

TYPE/APS button on the panel or AMS button 
on the RC. SCAN ON will be displayed. The 
radio will automatically store the 6 strongest 
available stations to the 6 preset memories of 
the current band. To stop auto store, press this 
button again.

•  Preset scan: Press AUDIO TYPE/APS 

button on the panel or AMS button on the RC. 
INTRO ON will be displayed. The receiver 
will scan the saved stations in all bands for 5 
seconds.

Mono/Stereo control 

(in FM radio mode)

Press repeatedly SELECT button on the 

panel or SEL button on the RC until the 
display shows ST ON (ST OFF). Press VOL+/
VOL- buttons on the RC or rotate VOLUME 
regulator on the panel to select between ST 
ON/OFF. ST ON means stereo reception of 
the signal; ST OFF means mono reception 
mode. Or press STEREO button on the RC to 
switch stereo reception on/off. Improvement 
of reception of distant stations can be done