Hyundai Electronics H-CDM8093 - Инструкция по эксплуатации - Страница 10

10

Operation

your desired radio band during Radio mode: 
FM1, FM2, FM3, AM1 (MW1), AM2 (MW2). 
In each set of the bands you can store up to 6 
preset stations, making total 30 preset memory 
stations.

Auto/Manual tuning

Press and hold PREVIOUS/NEXT buttons 

to display MANU TUNE. Now you can press 
these buttons repeatedly to adjust the needed 
frequency manually.

To adjust the needed frequency 

automatically, press PREVIOUS/NEXT 
buttons. The radio will seek to the next down or 
up strong and clear frequency station. Repeat 
this action to seek for other desired stations. 

Programming tuner stations

There are six numbered preset buttons, 

under which you can store and recall stations 
for each band. Select the needed station, 
then press and hold a preset button. The 
station will be saved in the memory under 
the corresponding number. To recall a stored 
station, press the corresponding preset button.

Automatic store/preset scan

Automatic store
Press and hold F/PS button. The radio will 

automatically store the 6 strongest available 
stations to the 6 preset memories of the 3 FM or 
2 MW bands (depending on which is current). 
To stop auto store, press this button again.

Preset scan
Press F/PS button, the receiver will scan the 

saved stations in the current band.

Mono/Stereo control 

(in FM radio mode)

Press SEL button until the display shows 

STEREO (MONO). Turn VOLUME knob to 
switch between stereo reception or mono 
reception.

Improvement of reception of distant stations 

can be done by selecting mono mode, which 
may cut down some reception noise.

Local radio station search

Press SEL button to choose LOCAL (DX). 

When the LOCAL function is on, the local 
stations (stations with weak radio signal) can 
be played. When the DX function is on both 
local and distant stations (stations with strong 
radio signal) can be played.

RDS function

RDS (Radio Data System) service availability 

varies with areas. Please understand if RDS 
service is not available in you area, the 
following service is not available, either.

AF (Alternative Frequencies) 

function

Press AF button on the panel to turn the AF 

function on or off.

When the radio signal strength is poor, 

enabling the AF function will allow the unit to 
automatically search another station with the 
same PI (Program Identification) as the current 
station but with a stronger signal, so that 
you do not have to retune the stations when 
driving between different transmitter coverage 
areas. When AF symbol is on, it means RDS 
information is received; when AF symbol is 
flashing, it means RDS information is not yet 
received.

PS (Program Service name): the name of 

station will be display instead of frequency.

If RDS service is not available in your area, 

turn off the AF mode. Default setting is ON.

TA (Traffic Alarm) function

Press TA button to turn TA function on or off.
In TA mode traffic program will be 

automatically searched, until the program is 
received. When traffic announcement is received 
the unit will temporarily switch to the tuner mode 
(regardless of the current mode) and begin 
broadcasting the announcement. After the 
traffic announcement is over, it will return to the 
previous mode and volume level. To interrupt 
traffic announcement press TAbutton shortly; it 
will not switch off the TA mode.