Hyundai Electronics H-CCR8089 - Инструкция по эксплуатации - Страница 10

10

Operation

ST: Set radio reception at STEREO or 

MONO mode. Improvement of reception of 
distant stations can be done by selecting mono 
mode, which may cut down some reception 
noise. To select stereo or mono you can also 
press STEREO/MONO button on the RC.

Time: Set the current time.
Time: Select 12-/24-hour time mode.
Beep: ON (beep sound will be heard when 

buttons are pressed) and OFF (no beep sound 
for button pressing).

Clock: Select ON to show the current time 

on the display. Select OFF not to show time.

Retune: 30S/60S. RETUNE refers to the 

time period the unit allows for radio scan when 
reception is interrupted. “30S” represents 
a time period of 30 seconds and “60S” 
represents a time period of 60 seconds.

Mask: DPI/ALL. During DPI mode, the unit 

will mask only the AF which has different PI, 
this is the default mode; during ALL mode, the 
unit will mask the AF which has different PI and 
no RDS signal with high field strength.

TA: Seek/Alarm. In SEEK mode, the unit will 

seek for traffic announcement program when 
TA is pressed; in ALARM mode, no TA/TP is 
displayed and the alarm is set off.

PICTURE
Mode: select picture mode: STD/SOFT/

BRIGHT/USER.

Brightness: Supports 50 levels.
Color: Supports 50 levels.
Contrast: Supports 50 levels.

EQ
Mode: EQ OFF => POP => ROCK => 

CLASSIC => JAZZ => FLAT.

Bass: support 14 levels. Default level is 0.
Treble:  support 14 levels. Default level is 0.
AUDIO
Balance: support 7 levels for each left and 

right channel.

Fade: support 7 levels for each front and 

rear channel.

Loud: Set loudness on or off. LOUD function 

is to emphasize the bass output.

General operations

Turning on/off

Press POWER/MUTE button on front panel 

or press POWER button on the  RC  to turn on 
the unit. Press and hold one of these buttons to 
switch the unit off.

Volume control

Rotate VOLUME regulator or press VOL+/

VOL- buttons on the RC to adjust the volume 
level.

Mute function

Press PWR/MUTE button on the panel or 

MUTE button on the RC to turn the sound off. 
Press it again or adjust the volume to turn the 
sound on.

Setting the sound characteristics

•  Press repeatedly SEL button on the RC 

to enter the audio setting menu consisting of 
following items: VOL (Volume) => BAS (Bass) 
=> TRE (Treble) => BAL (Balance) => FAD 
(Fader).

•  Press VOL+/VOL- buttons on the RC or 

rotate VOL button on front panel to adjust the 
selected item.

  If you turn off the power all the settings 

of each mode will be saved. If you don’t adjust 
setting within 5 seconds after selecting the 
desired setting, the unit will automatically return 
to the current mode.

System setup

•  Press MENU button to enter the setting 

mode.

•  In the menu press LEFT/RIGHT cursor 

buttons on the RC to select a setting page. 
Press UP/DOWN cursor buttons on the RC to 
choose a setting.

•  Rotate VOLUME knob on the panel or 

press VOL+/VOL- buttons on the RC to adjust 
a setting.

•  Following setting pages are available:
SETUP