Timberk On/Off AC TIM 60LC ST5 - Инструкция по эксплуатации - Страница 8

www.timberk.com • Electric air conditioner

8

Emergency control shall be used if the remote control board is lost or 

broken, or batteries are low. Using an emergency control button (17, Fig. 

2) situated on the indoor unit control panel you may select COOL or AUTO 

mode of the conditioner work. Pressing this button, select a mode of the 

conditioner work: AUTO, COOL, the conditioner is OFF, AUTO again, etc.

7. OPERATING MODES

1. On-off button the air conditioner
2. Mode button mode selection
3. Speed Button - fan speed
4. Button        temperature increase
5.        button reduce temperature
6. Sleep Button - Night mode
7. IFavor button allows you to return the air conditioner settings
8. When the IFeel mode, the display shows the temperature in the room, 

switched off - set
9. Turn on / off display
10. Timer button - switch timer
11. Not available for this series
12. Swing button to change the direction of the vertical blinds

Work with remote control board

Mounting and replacement of batteries: mount two LR03 alkaline batteries, 

according to polarity indicated on the remote control board.
In order to avoid malfunction of the remote control board do not insert used 

batteries or batteries of various types.
If the conditioner is not used for a long time, remove batteries from the 

board or else electrolyte may leak and damage the board.
In normal operation of the conditioner average service life of batteries will 

be about a half-year.
Replace batteries, if command receiving is not confirmed with an audio 

signal, or if the display does not show a sign of command transfer.
When generating commands from the remote control board, point an IR-

radiator on a remote-control signal receiver situated on the indoor unit. 

Hold the remote control board at the distance of no more than 8 m from 

the indoor unit.

13. Not available for this series
14. Turbo button (maximum fan speed)
15. Not available for this series
16. The Panel control panel display
17. Not available for this series

AUTO mode

The auto mode on and off is turned on and off with the use of the button 

“MODE” on the remote control board.
1. While working in the AUTO mode, a microprocessor will automatically 

select COOL, FAN, HEAT or DRY modes based on the difference between 

actual and preset air temperature indoors.
2. If the AUTO mode does not provide comfort conditions, select the mode 

manually.

COOL, HEAT and FAN

1. Turn the conditioner on pressing the «ON/OFF» button.
2. Pressing the «MODE» button, select COOL, HEAT or FAN mode 

manually.

Fig. 3