Timberk On/Off AC TIM 60LC ST5 - Инструкция по эксплуатации - Страница 10

www.timberk.com • Electric air conditioner

10

9. TROUBLESHOOTING

Failures and their possible reasons:

Failure

Possible reason

Actions

The conditioner does 

not work

Interruptions in power supply

Wait for restoration of power 
supply

Batteries in the remote control 
board are low

Replace the batteries

Time of tuming on is set by 
the timer

Wait till the conditooner turns 
on by the timer or cancel the 
timer setting

Insufficient cooling or 

heating capacity

The set air temperature is too 
high or too low

Set the air temperature 
correctly

The air filter is clogged with dust

    Clean the air filter

Foreign objects block the air intel 
and retum air grillages of the 
outdoor unit

     Remove foreign objects

The conditioner works, 

but does not cool or 

heat the room 

A three-minute delay of 
compressor tuming on

     Wait a little

The air temperature is set 
incorrectly

Set the temperature correctly

10. TRANSPORTATIOM AND STORAGE

Temperature 

requirements*
Humidity 

requirements*

We are exploring new technologies and we constantly improving the quality 

of our products. That’s why specifications, design and accessories are 

subject to change without any specific notice.

* This product must have storage in dry, well-ventilated space of warehouse 

at the temperature not lower than -30°

Transportation and 

storage

From -30° to +50°

From 15% to 85% 

(without a condensate)

11.SERVICE LIFE

12. UTILIZATION RULES

Service life of the appliance is 10 years provided that the respective 

installation and operation rules are observed.
Date of the conditioner manufacture is shown in a serial number of the 

device. For more details, please, ask a shop assistant.

Upon expiration of the service life, the appliance should be utilized in 

accordance with norms, regulations and procedures effective in the place 

of utilization.

To remove the filter, open the air inlet of the indoor unit panel. Press the 

locks to the center and pull the grillages down. Remove the air inlet. 

Remove the air filter. Clean the filter with a vacuum cleaner or rinse it in 

clean water. If the filter is contaminated heavily, clean it with a soft brush 

and wash in diluted washing solution, then dry it in a cool place.
While cleaning the filter with the vacuum cleaner, hold it with contaminated 

surface up. While washing the filter in water, hold it with contaminated 

surface down.
Do not dry the filter in the sun or near a fire.
Set the air filter to initial position and close an air inlet cover