Timberk AC TIM 09H P5BU - Инструкция по эксплуатации - Страница 9

www.timberk.com • Electric air conditioner

9

Installation of the filter is performed in the reverse order.
Filter cleaning
At first, carefully clean the filters by means of vacuum cleaners. Then 

immerse the filter in warm water (about 40°C) with a soft detergent, 

wash it and dry it without exposure to direct sunlight.
Air intakes (heat exchangers)
Use a vacuum cleaner for cleaning.
Case
Wipe the surface by a damp cloth and dry it by a soft dry cloth.
Automatic condensate removal
Condensate is automatically removed from the unit. Moisture inside the 

unit starts to evaporate and is removed from the unit through an air duct 

(or an air diffuser) in the form of steam.

Fig. 11.

9. TROUBLESHOOTING

Trouble

Cause

Troubleshooting method

The air conditioner is not switched on 

when Power button is pressed

The tank fill-up 
indicator is flashing, the 
condensate collection 
tray is filled up

Drain water from the tray

Actual room temperature 
is higher than the set one 
(in heating mode)

Set the temperature correctly

The air conditioner switches in heating 

mode

Automatic overheating 
protection is tripped. 
The unit is switched off 
in case the outlet air 
temperature goes higher 
than 70°C

Wait until the air conditioner 
cools down and switch it on 
again

Loud noise or strong vibration

The air conditioner is 
installed on an inclined or 
unsmooth surface

Install the air conditioner on a 
smooth horizontal surface

A noise, resembling a gurgle of water

Noise emerges due to 
refrigerant flow in pipes

It is normal

Trouble

Cause

Troubleshooting method

E1

Short circuit on a 
temperature sensor or a 
processor board

Contact an authorized service 
center

E2

Short circuit between 
a copper pipe of the 
temperature sensor and 
the processor board 
wiring

Contact an authorized service 
center

E4

It indicates the tank is 
filled up with water or 
the plug is connected 
incorrectly

Remove the rubber plug, located 
at the bottom of the unit, and 
drain water. Then check it the 
plug is connected correctly.

Error codes for LCD-display models