Mitsubishi Electric MSZ-LN25VGR - Инструкция по эксплуатации - Страница 6

En-5

● OPERATING INSTRUCTIONS ●

Installation position: 

Left: 

Distance to objects (wall, cabinet, etc.) is less than 50 cm to the left

Center:  Distance to objects (wall, cabinet, etc.) is more than 50 cm to the left 

and right

Right:  Distance to objects (wall, cabinet, etc.) is less than 50 cm to the right

Setting the installation position

Be sure to set the remote controller in accordance with the installed position of 

the indoor unit.

Before operation:

  Insert  the  power  supply  plug  into  the  power  outlet  and/or 

turn the breaker on.

Installing the remote controller batteries

1.

 Remove the front lid.

2.

 Insert the negative 

pole of AAA alkaline 

batteries fi rst.

3.

 Install the front lid.

4.

 Press RESET.

Setting current time

1.

 Press CLOCK.

4.

 Press CLOCK again.

2.

 Press either the TIME button 

or the TIMER buttons to set 

the time.

Each press increases/decreas-

es the time by 1 minute (10 

minutes when pressed longer).

3.

 Press the DAY button 

to set the day.

Area

Left

Center

Right

Remote controller 

display

(Left)  (Center) 

(Right)

P

REPARATION  BEFORE  OPERATION

Hold down 

 on the remote controller for 2 sec-

onds to enter the position setting mode.

Select the target installation position by pressing 

. 

(Each press of the 

 displays the positions in 

order:)

Press 

 to complete the position setting.

Note:

The installation position can be set only when all the following conditions are met:

•  The remote controller is powered off. 

•  Weekly timer is not set.

•  Weekly timer is not being edited.

1

2

3

(Center) 

(Right) 

(Left)

Note:

•  Make sure the polarity of the batteries is correct.

•  Do not use manganese batteries and leaking batteries. The remote controller 

could malfunction.

•  Do not use rechargeable batteries.

•  The battery replacement indicator lights up when the battery is running low. 

In about 7 days after the indicator starts lights up, the remote controller stops 

working.

•  Replace all batteries with new ones of the same type.

•  Batteries can be used for approximately 1 year. However, batteries with ex-

pired shelf lives last shorter.

•  Press RESET gently using a thin instrument.

  If  the  RESET  button  is  not  pressed,  the  remote  controller  may  not  operate 

correctly.

Note:

•  Press CLOCK gently using a thin instrument.

Note:

How to set remote controller exclusively for a particular indoor unit

A maximum of 4 indoor units with wireless remote controllers can be used in a room.

To operate the indoor units individually with each remote controller, assign a number 

to each remote controller according to the number of the indoor unit.

This setting can be set only when all the following conditions are met:

•  The remote controller is powered OFF.

(1)  Hold down 

 button on the remote controller for 2 seconds to enter the pairing 

mode.

(2)  Press 

 button again and assign a number to each remote controller.

Each press of 

 button advances the number in the following order: 1 → 2 → 

3 → 4.

(3)  Press 

 button to complete the pairing setting.

After you turn the breaker ON, the remote controller that fi rst sends a signal to an 

indoor unit will be regarded as the remote controller for the indoor unit.

Once  they  are  set,  the  indoor  unit  will  only  receive  the  signal  from  the  assigned 

remote controller afterwards.

JG79Y370H02_01En.indd   5

2018/01/18   14:21:47