Mitsubishi Electric MSZ-LN25VGR - Инструкция по эксплуатации - Страница 19

En-18

Installation place

Avoid installing the air conditioner in the following places.

•  Where there is much machine oil.

•  Salty places such as the seaside.

•  Where sulfi de gas is generated such as hot spring, sewage, waste water.

•  Where oil is splashed or where the area is fi lled with oily smoke (such as cooking areas 

and factories, in which the properties of plastic could be changed and damaged).

•  Where there is high-frequency or wireless equipment.

•  Where the air from the outdoor unit air outlet is blocked.

•  Where the operation sound or air from the outdoor unit bothers the house next door.

•  The  mounting  height  of  indoor  unit  1.8  m  to  2.3  m  is  recommended.  If  it  is 

impossible, please consult your dealer.

•  Do  not  operate  the  air  conditioner  during  interior  construction  and  fi nishing 

work, or while waxing the fl oor. Before operating the air conditioner, ventilate 

the room well after such work is performed. Otherwise, it may cause volatile 

elements  to  adhere  inside  the  air  conditioner,  resulting  in  water  leakage  or 

scattering of dew.

•  Do not use the Wi-Fi interface nearby the medical electrical equipment or peo-

ple who have a medical device such as a cardiac pacemaker or an implantable 

cardioverter-defi brillator.

  It  can  cause  an  accident  due  to  malfunctions  of  the  medical  equipment  or 

device.

•  This equipment should be installed and operated with a minimum distance of 

20 cm between the device and the user or bystanders.

•  Do  not  use  the  Wi-Fi  interface  nearby  other  wireless  devices,  microwaves, 

cordless phones, or facsimiles.

  It can cause malfunctions.

Electrical work

•  Provide an exclusive circuit for the power supply of the air conditioner.

•  Be sure to observe the breaker capacity.

If you have any questions, consult your dealer.

I

NSTALLATION  PLACE  AND  

ELECTRICAL  WORK

1

Operate by COOL mode with the highest temperature 

set or FAN mode for 3 to 4 hours. 

 Page 7 

•  This dries the inside of the unit.

•  Moisture  in  the  air  conditioner  contributes  to  favorable  conditions  for 

growth of fungi, such as mold.

2

Press 

 to stop the operation.

3

Turn off the breaker and/or disconnect the power sup-

ply plug.

4

Remove all batteries from the remote controller.

When using the air conditioner again:

1

Clean the air fi lter. 

 Page 14 

2

Check that the air inlet and outlet of the indoor and 

outdoor units are not blocked.

3

Check that the earth is connected correctly.

4

Refer to the “PREPARATION BEFORE OPERATION”, 

and follow the instructions. 

 Page 5 

W

HEN  THE  AIR  CONDITIONER  IS  NOT  

GOING  TO  BE  USED  FOR  A  LONG  TIME

To prevent the effects 

of a fl uorescent lamp, 

keep as far apart as 

possible.

wall, etc.

Inverter-type 

fl uorescent lamp

Keep a space 

to prevent 

the picture 

distortion or 

the noise.

1 m 

or 

more

Radio

100 mm or 

more

TV

Cordless 

phone or 

Portable 

phone

3 m or more

1 m 

or more

The  installation  location  of  the  outdoor 

unit  should  be  at  least  3  m  away  from 

the antennas for TV sets, radios, etc. In 

areas where the reception is weak, pro-

vide greater space between the outdoor 

unit  and  the  antenna  of  the  affected 

device if operation of the air conditioner 

interferes with radio or TV reception.

(25, 35, 50VG/50HZ, 60)

200/500 mm or more

For the optimum ef-

fi ciency and to extend 

the life time of using, 

the outdoor unit 

should be installed in 

a well-ventilated dry 

place.

Operation indicator lamp

When the remote controller cannot be used...

Emergency  operation  can  be  activated  by  pressing  the  emergency  operation 

switch (E.O.SW) on the indoor unit.

Each time the E.O.SW is pressed, the operation changes in 

the following order:

Set temperature : 24°C

Fan speed : Medium

Horizontal vane : Auto

Emergency COOL

Emergency HEAT

Stop

Note:

•  The  fi rst  30  minutes  of  operation  is  test  run.  Temperature  control  does  not 

work, and fan speed is set to High.

•  In the emergency heating operation, the fan speed gradually rises to blow out 

warm air.

•  In  the  emergency  cooling  operation,  the  horizontal  vanes’  position  will  be 

reset in about a minute, then the operation will start.

E

MERGENCY  OPERATION

If a power failure occurs or the main power is turned off during operation, “Auto 

restart function” automatically starts operation in the same mode as the one set 

with the remote controller just before the shutoff of the main power. When timer is 

set, timer setting is cancelled and the unit starts operation when power is resumed.

If you do not want to use this function, please consult the service repre-

sentative because the setting of the unit needs to be changed.

A

UTO  RESTART  FUNCTION

JG79Y370H02_01En.indd   18

2018/01/18   14:21:55