Krups EA819N10 Arabica - Инструкция по эксплуатации - Страница 32

30

When the pictogram

is displayed, you may start the cleaning program:

- Press the settings and maintenance key 

.

- Ensure that the pictogram

is selected, otherwise use the navigation key 

.

- The pictogram

flashes.

The cleaning cycle: environ 10 minutes

- Lift the cup tray 

(J)

.

- Insert the KRUPS cleaning tablet in the opening intended for this purpose 

(I)

.

- Fill the water reservoir up to its maximum level of 1.7L 

(2)

.

- Empty the coffee grounds collector and the drip tray 

(34, 35, 36

).

- Place the 600 ml container under the coffee outlets and the steam nozzle 

(7)

.

- Press the START 

.

- The pictogram 

stops flashing.

- The first phase of the cleaning cycle starts.
- At the end of this cycle, the pictogram

flashes.

- Empty the container and the drip tray and put them back in place.

The rinse cycle: environ 3 minutes

- Press the START 

.

- The pictogram 

stops flashing.

- At the end of this cycle, empty the container and drip tray 

(34, 35, 36)

.

- Put the drip tray back in place.

Le cycle de nettoyage est terminé, le menu de recette café apparait, vous pouvez de nouveau utiliser votre machine.

Important: 

if you turn off or unplug your machine during cleaning or in the event of a power failure, the cleaning

program will start again at the step under way during the incident. It will not be possible to postpone

this operation, this is compulsory in order to rinse the water circuit. In this case, a new cleaning tablet

may  be  necessary.  Properly  perform  the  entire  cleaning  program  to  eliminate  any  trace  of  cleaning

product harmful to health.

Descaling program: Approximately 20 minutes

Running your machine's descaling program ensures that it is operating properly and eliminates any limescale deposits
that may influence the taste of the coffee.
The  frequency  at  which  this  program  is  run  depends  on  the  quality  of  water  used  and  whether  or  not  a  Claris  Aqua
Filter System filter cartridge is used. The harder your water, the greater the frequency of descaling.

Important: 

ensure that you disconnect the milk pot 

(37)

and remove the Claris Aqua Filter System cartridge if it is

fitted before starting a descaling cycle.

To perform this descaling, you will need:

- 1 dose of KRUPS descaler

- 1 container (minimum 600 ml)

The cycle will link three phases:

- 1 cleaning phase

- 1st rinse phase

- 2nd rinse phase

When should this program be performed?

- Each quarter.
- When the appliance advises you by lighting up the pictogram

.

Important: 

You are not obliged to immediately perform the descaling program when the appliance requests it, but

you  must  perform  it  as  soon  as  possible.  If  the  descaling  is  postponed,  the  pictogram  will  remain

displayed so long as the operation has not been performed.

It is recommended to perform the descaling to eliminate any limescale deposits that may influence the

taste of coffee.

The descaling program is an intermittent cycle; do not place hands under the steam outlet.

!

!

!

KR_ARABICA-LATTE_EA819_8020002251_EN.qxp_Mise en page 1  17/08/2018  14:02  Page30