ADA Cube 360 Green Professional Edition - Инструкция по эксплуатации - Страница 5

5

If the switch (5) is OFF, that means that the line laser is off, the compensator 

is also locked.
3. Press button (1) to switch the vertical beam on. Press button (1)once again 
to switch the horizontal beam on. Press button (1) to switch the horizontal 
and vertical beams on. Switch on only necessary laser lines in order to save
battery life

.

4. Press button (2). The mode “outside” is activated. Press button (2) once 
again. The tool begins to operate in “inside” mode. Use the detector of laser 
beam for this mode. See the operating manual for the operation with detector.

TO CHECK THE ACCURACY

          TO CHECK THE ACCURACY OF LINE LASER  (SLOPE OF PLANE)

Place line laser on the tripod 5m away from the wall so the horizontal laser 
line  will be directed to the wall. 
Switch on the power.  The line laser starts to self-level. Mark point A on the 
wall to show the contact of laser beam with the wall. Turn the line laser by 

90° and mark points В, С, D on the wall. Measure distance “h” between the 

highest and lowest points (these are A and D points in the picture).

If  “h”is  ≤ 6 mm, the measurement accuracy is good. If “h” exceeds 6 mm, 

apply service center.

TO CHECK PLUMB

Choose a wall and set laser 5m away from the wall. Mark point A on the 
wall, please note the distance from point A to ground should be 3m. Hang 

a plumb line from A point to ground and find a plumb point B on ground. 

turn on the laser and make the vertical laser line meet the point B, along 
the vertical laser line on the wall and measure the distance 3m from point 
B to another point C. Point C must be on the vertical laser line, it means the 
height of C point is 3m.
Measure the distance from point A to point C, if the distance is over 2 mm, 
please, contact with seller to calibrate the laser.

English

3