Liebherr CTNesf 3653 Premium NoFrost - Инструкция по эксплуатации - Страница 3

9

Setting up

•  The floor on which the appliance stands should be horizontal 

and level. To compensate for any unevenness, adjust the 

height of the feet with the open-ended wrench supplied.

•  Always position the appliance directly up against the wall.

•  The ventilation grilles should not be obstructed.

• Condensation may form on the outside of the refrigerator/freez-

er during periods of high humidity.

   Constant ventilation of the installation site is recommend.

•  Do not place heat-emitting appliances, e.g. microwave oven, 

toaster, etc., on top of the appliance.

•

In order to avoid the risk of fire, do not place any burning candles, 

lamps or other objects with open flames on the refrigerator/freezer.

•  Standard EN 37 specifies that the room in which you install your ap-

pliance must have a volume of 1 m

3

 per  g of R 600a refrigerant used 

in the appliance, so as to avoid the formation of inflammable gas/air 

mixtures in the room where the appliance is located in the event of a 

leak in the refrigerant circuit. The quantity of refrigerant used in your 

appliance is indicated on the type plate on the inside of the appliance.

• Fire hazard due to dampness!

   If live parts or the mains lead become damp this may cause 

short circuits.

- The appliance is designed for use in enclosed areas. Do not 

operate the appliance outdoors or in areas where it is exposed 

to splash water or damp conditions.

• CAUTION! Risk of injury and danger of damage as a result of 

incorrect transport!

- Transport the appliance in a packed condition.

- Transport the appliance upright.

- Do not transport the appliance without assistance.

•  The appliance may be moved only when it is empty.

Connecting to the mains

Power supply (a.c.) and voltage at the operating point must 

comply with the details on the type plate, which is located in the 

refrigerator compartment on the left-hand side. The socket must 

be fused with a 10 A fuse or higher, it must be away from the rear 

of the appliance and must be easily accessible.

•  Do not connect the appliance to the supply with other equip-

ment using a distribution outlet - risk of overheating.

•

 Connect the appliance with a properly earthed fused plug 

and socket only.

The wires in the mains lead are coloured in accordance with the 

following code: green/yellow = earth, blue = neutral, brown = live. 

Warning! This appliance must be earthed.

Audible warning on/off button

The appliance is equipped with an alarm function.

Audible door alarm:

If an appliance door is left open for more than 60 seconds, 

the audible warning signal will sound. Press the audible 

warning on/off button to cancel the alarm. The alarm switches 

back to standby when the door is shut.

Audible/visual temperature alarm:

If the temperature in the freezer compartment rises too high, 

the audible warning signal will sound and the LED* in the 

audible warning on/off button will flash.
Press the audible warning on/off button to cancel the alarm. 

The LED* will stop flashing and will light continuously. The 

LED* will go out as soon as the temperature in the freezer 

compartment is low enough.

This can be caused by:

•  the freezer door being left open for a long time, allowing 

warm ambient air to enter;

•  a long power failure;

•  a fault in the appliance.
In each case, make sure food has not defrosted or perished. 

If the visual warning LED* does not go out, contact the cus-

tomer service department (see section on “

Malfunctions

”).

GB

Saving energy

-  Always ensure good ventilation. Do not cover ventilation open-

ings or grille.

-  Always keep fan louvres clear.

-  Do not place appliance in areas of direct sunlight or next to a 

stove, heater or similar object.

-  The energy consumption depends on the installation condi-

tions, e.g. the ambient temperature.

-  Keep the time the appliance is open to a minimum. 

-  Store food logically.

-  Ensure that all food is well packed and covered for storage.

  This will prevent frost from forming.

-  First cool warm food to room temperature before storing it.

-  Defrost frozen food in the refrigerator.

-  Empty and switch off refrigerating unit for 

longer vacation periods.

Accumulated dust increases the energy 

consumption: 

-  Once a year, dust the refrigerating unit 

together with the metal grille of the heat 

exchanger at the back of the appliance.

9

7

5

3

1

-15

-18

-21

-25

-32

°C

You are advised to clean the appliance before switching it on for 

the first time (see "Cleaning").

Put the appliance into operation approximately 4 hours before 

loading with frozen food for the first time. Only insert frozen food 

when the freezer compartment is cold.

Switching the appliance on and off

 Fig.

A1

Switching on:

To switch on the entire appliance, you only 

need to switch on the freezer section. The fridge section is 

automatically switched on, too.

W

Switching on the freezer section:

-   Briefly press the On/Off button 

9

.

  The temperature displays light up. The appliance is 

switched on.

W

  Switching on the fridge section:

When the fridge section is switched on, the freezer section is 

switched on, too.

-  Briefly press the On/Off button 

1

.

  The temperature displays light up. The fridge and freezer 

sections are switched on.

Switching off

-    To switch off the entire appliance you only need to switch 

off the freezer section. The fridge section is automatically 

switched off, too

.

W

 Switching off the freezer section:

-   Press the On/Off button 

9

 for approx. 2s.

     The temperature displays are dark. The appliance is 

switched off.

W

Switching off the fridge section:

-  Press the On/Off button 

1

.

     The interior lighting is dark. The temperature display of the 

fridge section is dark.

If only the fridge section is to be switched off, e.g. during 

holiday periods, always make sure that: the temperature 

display on the freezer sections remains lit.

Adjusting the temperature 

Fig.

 A1

W

Fridge section:

The temperature depends on the following factors:

-    The frequency of opening the door

-    The room temperature of the installation location

-    The type, temperature and quantity of the frozen food

     Recommended temperature setting: 5 °C.

     The temperature can be changed progressively. When the 

setting 1 °C is reached, it begins again at 9 °C.

-    Press the adjustment button

3

until the LED of the desired 

temperature lights up.

* according to model and design