Sharp SJ-FS97VSL - Инструкция по эксплуатации - Страница 33

33

ENGLISH

WARNING

Unplug the refrigerator first to prevent electric shock.

■

Do not splash water directly on the outer cabinet or 

■

the interior. This may lead to rusting and deterioration 

of the electrical insulation.

IMPORTANT

To prevent cracking on inside surfaces and plastic 

components, follow these tips.

Wipe any food oils adhered to plastic components.

•

Some household chemicals may cause damage, so use 

•

only diluted washing-up liquid (soapy water).

If  undiluted  detergent  is  used  or  soapy  water  is  not  wiped 

•

off thoroughly, cracking of plastic parts can result.

1

  Remove the water tank and clean and dry it thoroughly 

to prevent water stain or bacteria from being attached. 

(Once a week)

2

  Remove the accessories e.g. shelves from the cabinet 

and door. Wash them in warm soapy dishwashing water; 

rinse in clean water and dry. 

3

  Clean the inside with a cloth soaked in warm soapy 

dishwashing water. Then, use cold water to wipe off 

soapy water.

4

  Wipe the exterior with a soft cloth each time it is soiled.

5

  Clean the Magnetic door seal with a toothbrush and 

warm soapy dishwashing water.

6

  Wipe the control panel with the dry cloth.

NOTE

To prevent damage to your refrigerator, do not use heavy 

•

duty cleansers or solvents (lacquer, paint, polishing powder, 

benzine, boiled water, etc.).

If the power supply is disconnected, please wait for at least 

•

5 minutes before re-connecting power.

The glass shelves weigh approximately 3 kg each. Hold firmly 

•

when removing from the cabinet or carrying.

Do not drop objects inside the refrigerator or strike the inner 

•

wall. This may cause the inner surface to crack.

Defrosting

Defrosting is fully automatic due to a unique energy saving 

system.

When the compartment light is blown

Contact the service agent approved by SHARP to request a 

replacement compartment light. The compartment light is not 

to be removed other than by qualified service personnel.

When transporting 

Before transporting, empty the ice tray by the following 

•

procedure.

Empty the water tank and the ice storage box.

1

Set Ice tray cleaning mode “ON”. 

2

(Refer to “

Ice tray cleaning

”.)

About 40sec. later, empty water or ice of ice storage 

3

box when you hear the ending sound.

Wipe up water in the evaporating pan. Before wiping up 

•

the water, wait more than 1 hour after pulling out the plug 

because refrigeration cycle equipment is extremely hot. 

(The evaporating pan is located on the rear of the product.)

The casters allow the refrigerator to 

•

move back and forth.

Carry the refrigerator by holding the handles located on the 

•

rear and bottom.

Switching off your refrigerator

If you switch your refrigerator off when you are going away 

for an extended period, remove all food, clean the interior 

thoroughly. Remove the power cord plug from the power 

socket and leave all doors open.

CARE AND CLEANING

Casters

Evaporating pan

(B375).indb   33

2012/09/11   13:35:13