Electrolux ERN 29650 - Инструкция по эксплуатации - Страница 46

46

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by ±6% of the rated voltage.

For operation with different voltages, a suitably sized
auto-transformer must be used.

The appliance must be earthed.

The power supply cable plug is provided with a
contact for this purpose.

If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.

INSTALLATION

Location

The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. 

For building into kitchen units follow the special “
Building-in” instructions given.

Attention 

It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.

B

A

Shelf holders

Your appliance is equipped with shelf retainers that
make it possible to secure the shelves during
transportation. 

To remove them proceed as follows:

Raise the shelf from the back, push it in the direction
of the arrow until it is freed and remove the retainers.

The Manufacturer declines all responsibility if
the above safety precautions are not observed.

This appliance complies with the following

E.E.C. Directives:

- 87/308 EEC

of 2/6/87 relative to radio interference

suppression.

- 73/23 EEC

of 19.2.73 (Low Voltage Directive) and

subsequent modifications;

- 89/336 EEC

of 3.5.89 (Electromagnetic Compatibility

Directive) and subsequent modifications.