Грили Gaggenau VR 421-110 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Technical data
Total connected load: 3 000 W
VR 421-110
220-240 V / 400 V 2N
Important notes on installation
This appliance can be combined with all Gaggenau
Vario 400 Series appliances.
This appliance may be installed in kitchen
combinations made of wood or similar combustible
materials without taking additional safety measures.
The built-in furniture and worktop where the
appliance is installed must be heat resistant up to
temperatures of 200° F/90° C.
The appliance must only be connected by an
authorised specialist, paying attention to the
relevant regulations of the power supply companies
and the regional construction regulations.
The mains connecting cable must at least
correspond to type H 05 VV-F (3 x 1.5 mm
2
). Pay
attention to the data on the rating plate. The
appliance must be properly grounded.
When connecting electrical appliances in the
proximity of cooking surfaces, make sure that
connecting cables do not come into contact with hot
cooking surfaces.
The installation technician is responsible for the
correct functioning of the appliance at the place of
installation. He must instruct the user on how to
disconnect the appliance from electricity in an
emergency.
After unpacking, check the appliance for any
transportation damage and report this immediately
to the transportation company.
Only install the grill with the appliance cover fitted.
The appliance cover serves as a heat shield to the
back wall during use.
There must be a gap of at least 90 mm at the side
between the appliance and any walls or furnishings.
If all poles of the appliances cannot be isolated
from the mains by removing an accessible plug, an
isolating device with a contact gap of at least 3 mm
must be installed (e.g. domestic fuse).
No warranty claims can be lodged for any
damage resulting from failure to observe these
instructions. Pay attention to the “Important
notes" on page 3 and 4.
Subject to technical change without notice
14
9. Installation
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
