Грили Gaggenau VK 411-110 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
16
Technical data
Total connected load: 2 200W
AC 208/220-240 V / 60 Hz
Important notes on installation
This appliance can be combined with all Gaggenau
Vario 400 Series appliances.
Note: do not install the appliance directly next
to a deep fryer!
This appliance may be installed in kitchen combi-
nations made of wood or similar combustible
materials without taking additional safety measures.
The built-in furniture and worktop where the
appliance is installed must be heat resistant up to
temperatures of 200° F/90° C.
The appliance must only be connected by an
authorised specialist, paying attention to the
relevant regulations of the power supply companies
and the regional construction regulations.
When connecting electrical appliances in the
proximity of cooking surfaces, make sure that
connecting cables do not come into contact with
hot cooking surfaces.
The installation technician is responsible for the
correct functioning of the appliance at the place of
installation. He must instruct the user on how to
disconnect the appliance from electricity in an
emergency.
After unpacking, check the appliance for any
transportation damage and report this immediately
to the transportation company.
There must be a gap of at least 40 mm (1
9
/
16
´ ´ ) at
the side between the appliance and any walls or
furnishings.
The minimum distance from the trough base to the
nearest heat-sensitive parts is 10 mm (
13
/
32
´ ´ ).
An extractor hood must be installed if suspended
cupboards are installed over the steam cooker
because the steam might otherwise damage the
furniture.
If all poles of the appliances cannot be isolated
from the mains by removing an accessible plug, an
isolating device with a contact gap of at least 3 mm
must be installed (e.g. domestic fuse).
Only a qualified electrician should install this
appliance.
This appliance must be hardwired.
The mains connecting cable must at least
correspond to the type SJTO 3x16 AWG 105°C.
The mains connecting cable must only be
purchased through and connected by an
authorised specialist. The appliance must be
properly grounded. Pay attention to the
information on the rating plate.
No warranty claims can be lodged for any
damage resulting from failure to observe these
instructions. Pay attention to the “Important
notes" on page 3 and 4.
Subject to technical change without notice.
8. Installation
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
