Газонокосилки Husqvarna LC 551SP 9673432-02 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
To use the drive on the wheels
• Pull the drive bail in the direction of the handlebar.
(Fig. 46)
• For model LC 451V and model LC 551VBP: Adjust
the drive speed with the speed control on the left
side of the handle. Move the speed control forward
to increase the speed and rearward to decrease the
speed. (Fig. 47)
• Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
To stop the product (LC 451S,
LC 451V, LC 551SP)
• To stop the drive only, release the drive bail.
• To stop the engine, release the engine brake handle.
To stop the product (LC 551VBP)
• To stop the drive only, release the drive bail.
• To stop the engine, move the throttle control to the
stop position.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
Maintenance
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Maintenance schedule
CAUTION: Make sure that the air filter is up
and not against the ground when you tilt the
product. Risk of engine damage.
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 10.
Maintenance
Daily
Weekly
Monthly
Do a general inspection
X
Examine the oil level
X
Clean the product
X
Examine the cutting equipment
X
Examine the cutting cover *
X
Examine the engine brake handle * LC 451S, LC 451V, LC 551SP
X
Examine the blade brake control * LC 551VBP
X
Examine the muffler *
X
Examine the spark plug
X
Replace the oil (the first time after 5 h of use, then after each 50 h of
use)
X
Clean or replace the air filter
X
Examine the fuel system
X
929 - 002 -
13
