Greenworks GD82LM51 2502007 - Инструкция по эксплуатации - Страница 21

19

English (Original Instructions)

installed with the curved ends pointing up toward the 

mower deck and not down toward the ground. When 

seated properly, the blade should be flat against the 

fan.

■

Thread the blade bolt on the shaft and finger tighten.

■

Torque the blade bolt down clockwise using a torque 

wrench (not provided) to ensure the bolt is properly 

tightened. The recommended torque for the blade bolt 

is 62.5~71.5 kgfcm (350-400 in.-lb.).

TROUBLESHOOTING

Problem

Possible cause

Solution

Handle is not in position.

Carriage bolts are not seated 

properly.

Adjust the height of the handle and
make sure the carriage bolts are
seated properly.

Mower is not starting.

Battery is low in charge.

Charge the battery.

Battery is either inoperable or will 

not take a charge.

Replace the battery.

Mower is cutting grass unevenly.

Lawn is rough or uneven or cutting
height not set properly.

Move the wheels to a higher position.
All wheels must be placed in the
same cutting height for the mower to
cut evenly.

Mower is not mulching properly.

Wet grass clippings are sticking to
the underside of the deck.

Wait until the grass dries before
mowing.

Mower is hard to push.

High grass, rear of mower housing
and blade are dragging in heavy
grass, or cutting height too low.

Raise the cutting height.

Mower is not bagging properly.

Cutting height is set too low.

Raise the cutting height.

Mower is vibrating at higher speed.

Blade is unbalanced, excessively or
unevenly worn.

Replace the blade.

Motor shaft is bent.

Stop the motor, remove isolator key 

and battery, disconnect the power 

source, and inspect for damage. 

Have it repaired by an authorised 

service center before restarting.

Motor stops while cutting.

Cutting height is set too low.

Raise the cutting height.

Battery has no power.

Charge the battery.

If these solutions do not solve the problem contact your authorised service dealer.