FERM LMM1013 - Инструкция по эксплуатации - Страница 14

14

EN

 Immediately switch of the machine in the 
following cases:
- whenever you leave the machine,

-  before clearing blockages or unclogging 

chute,

-  before checking, cleaning or working on 

the machine,

-  after striking a foreign object. Inspect 

the machine for damage and make 
repairs before restarting and operating 

the machine;

 Be careful during adjustment of the 
machine to prevent entrapment of the 
fingers between moving blades and fixed 
parts of the machine.

Adjusting the cutting height 

Fig. A, L, M

Switch off the equipment, disconnect the 
plug and wait for the blade to stop. There 
is a risk of injury.

Depending on the preferred cutting height, you 
can adjust the wheel assembly in one of three 
positions.
1.  Put the lawn mower on its side.
2.  Grasp the wheel axle on both sides.
3.   Pull evenly on the axle and insert into one of the 

three notches, as shown on figure L. Ensure the 
left and right side of the axle are mounted in the 
same notch. Repeat this step for both axles. 
Ensure the front and rear axle are mounted 
in the same notch, so the lawn mower cuts 
parallel to the lawn.

4.   Each notch position resembles a cutting height, 

as shown on figure M.

   Position 1 resembles a cutting height of 30 mm.
   Position 2 resembles a cutting height of 50 mm.
   Position 3 resembles a cutting height of 70 mm.

Note:

 A higher cut height should be selected for 

the first cut of the season.

Securing the power cord 

Fig. A, N

Mount the cable into the cable strain relief (5) as 
shown on figure N.

Switching the machine on/off 

Fig. A, O

Do not start the mower if it is standing in 
long grass.

•   To start the machine, press and hold the safety 

button (3) and press the on/off switch (2). 
Whilst holding the on/off switch (2), you can 
release pressure on the safety button (3).

•   To stop the machine, release the on/off switch 

(2) and wait until cutting blade stops rotating.

Always work your way away from the cables to 
avoid cutting them, as shown on figure Q.

5. MAINTENANCE

Your mower has been designed to operate over a 
long period of time with minimum of maintenance. 
Continuous satisfactory operation depends upon 
proper mower care and regular cleaning.

•   Keep the mower clean and dry.
•   Regularly use a blunt scraper to remove grass 

and dirt from the mower

•   To clean the mower, use only mild soap and a 

damp cloth. Never let any liquid get inside the 
tool and never immerse any part of the tool 
into liquid. Do not use any abrasive or solvent - 
based cleaner.

Stop the blade(s) if the machine has to be tilted for 
transportation when crossing surfaces other than 
grass, and when transporting the machine to and 
from the area to be used.

Do not start the machine when standing in front of 
the discharge opening.

Always allow the machine to cool down before 
storing.

Replace worn or damaged parts for safety. Use 
only genuine replacement parts and accessories.