Bosch ROTAK 34 LI 0.600.881.E00 - Инструкция по эксплуатации - Страница 28

 English | 

27

Bosch Power Tools

F 016 L70 740 | (24.3.10)

The battery is equipped with temperature mon-
itoring that allows charging only in the tempera-
ture range between 0  ° C and 45  ° C. In this man-
ner, a high battery service life is achieved.

Note: 

The battery is supplied partially charged. 

To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any 
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the 
battery.
The lithium-ion battery is protected against 
deep discharging when used in the product. 
When the battery is discharged the product is 
switched off by a protective circuit and the 
product no longer operates.

Do not continue to press the 
On/Off switch after the garden 

product has been automatically switched off. 

The battery can be damaged.

Charging Procedure

The charging procedure starts as soon as the 
mains plug of the battery charger is plugged into 
the socket outlet and the battery 

8

 is inserted in-

to the charging compartment 

16

.

Due to the intelligent charging method, the 
charging condition of the battery is automatical-
ly detected and the battery is charged with the 
optimum charging current, depending on bat-
tery temperature and voltage.
This gives longer life to the battery and always 
leaves it fully charged when kept in the charger 
for storage.

Meaning of the Indication Elements

Control of the charging procedure is indicated 
via the charge control LEDs 

18

 and 

19

:

Rapid-charging Procedure

The rapid-charging procedure is 
indicated by 

flashing

 of the 

green charge control LED

19

.

During the charging procedure, the three green 
LEDs light up one after the other and briefly go 
out. The battery is fully charged when the three 
green LEDs light up continuously. The three 
LEDs go out again approx. 5 minutes after the 
battery has been fully charged.

Note: 

The rapid-charging procedure is only pos-

sible when the battery temperature is within the 
allowable charging temperature range, see sec-
tion “Technical Data”.

Battery Charged

Continuous lighting

 of the 

green charge control LED

19

signals that the battery is fully 
charged.

Additionally, a signal tone sounds for approx. 
2 seconds, which acoustically indicates that the 
battery is fully charged.
Afterwards, the battery can be removed for im-
mediate use.
With no battery inserted, 

continuous lighting

 of 

the 

green charge control LED

19

 indicates that 

the mains plug is plugged into the socket and 
that the battery charger is ready for operation.

Battery Temperature below 0 ° C and above 
45 ° C

Continuous lighting

 of the 

red 

LED

18

 indicates that the bat-

tery temperature is not within 
the rapid-charging temperature 

range of 0 ° C – 45 ° C. As soon as the allowable 
temperature range is reached, the battery 
charger automatically switches to rapid charg-
ing.
When the battery is not within the allowable 
temperature range, the red battery LED lights 
up when inserting the battery into the battery 
charger.

No charging procedure possible

If a different malfunction of the 
charging procedure is present, 
this will be indicated through 

flashing

 of the 

red charge con-

trol LED

18

.

WARNING

OBJ_BUCH-882-003.book  Page 27  Wednesday, March 24, 2010  10:57 AM