Bosch AdvancedRotak 660 - Инструкция по эксплуатации - Страница 31

 English | 

31

Bosch Power Tools

F 016 L81 767 | (29.11.17)

Areas left uncut

Mower requires more cuts to finish the garden 
/ too many objects in close proximity

Allow mower to run for 3 full cuts to cover whole lawn ar-
ea

Time slot not long enough for garden size

Increase mowing time slot or use Bosch AUTO Calendar 
Function

Distance between wire is too small

Increase distance between the wires around separate 
marked objects to at least 75cm

Leave at least 75cm between wire around marked object 
and wire at the edge of the lawn

Rough lawn conditions

Select uneven ground from Lawn condition within the 
menu. 

Flatten garden/remove bumps/mark out areas with pe-
rimeter wire  –  follow installation instructions

Grass too long

Mow garden to at least 40mm before using Indego.

Increase height of cut

Slopes in garden are too steep 

Ensure mower only operates on slopes of 15 degrees or 
less and full garden is not on a slope.

Mower cutting in wet grass conditions 

Do not set the mower to cut in bad weather conditions

Too many objects inside the garden

Remove objects/obstacles from inside the garden or de-
limit them with perimeter wire

Metal construction underneath or next to the 
lawn area

Follow instructions in installation guide for objects

Machine gets stuck in 
garden 

Mower cutting in wet grass conditions 

Do not set the mower to cut in bad weather conditions

Objects/obstacles not marked out 

Remove objects/obstacles from inside the garden or de-
limit them with perimeter wire

Newly laid turf

Change bump sensor/lawn condition setting to low sen-
sitivity/uneven.

Distance as far as possible the times between watering 
the lawn and the cutting schedule

Allow a few weeks for the soil to settle

Machine unintention-
ally cuts flowers etc. 
in garden or runs over 
certain obstacles

Objects/obstacles below 5 cm not marked out  Mark obstacle using perimeter wire leaving 30cm from 

object or remove objects/obstacles

Machine does not 
appear to cut logically

Logical cut system depends on the garden 
conditions (e.g. mower may go to the closest 
unmown area rather than to the last mowed 
spot) 

Mower does not always go in a straight line 
when traveling between areas

Wire crossed when marking an object

Further information available in installation guide
When area is not mowed or mower repeats action often: 
remap garden

No corrective action needed

Check wire is laid around object in a clockwise direction
Check installation

Perimeter wire keeps 
being cut 

Wire is not taut between pegs
Distance between pegs is more than 75cm

Make wire taut and ensure distance between pegs is 
maximum 75cm.
Use the wire connectors to repair the break. Avoid using 
a verticutter, scarifier, etc. over the perimeter wire

Problem

Possible Cause

Corrective Action

OBJ_BUCH-3008-003.book  Page 31  Wednesday, November 29, 2017  12:20 PM