Bosch AdvancedRotak 660 - Инструкция по эксплуатации - Страница 30

30

 | English 

F 016 L81 767 | (29.11.17)

Bosch Power Tools

Troubleshooting

Online Support

http://www.bosch-indego.com

Problem

Possible Cause

Corrective Action

The LED on docking 
station flashes

The perimeter wire is broken, too long or too 
short.  Wire not connected and mower not in 
the docking station

Check perimeter wire is not broken and is between 20 
and 250 meters in length. Then switch off and on power 
supply.

Follow instructions in Installation guide to install the 
mower.

Excessive vibrations/ 
noise

Blade nut/bolt loose

Tighten blade nut/bolt to torque of 2.5 Nm

Cutting blade damaged

Replace the blade

Machine not docking 
reliably

Perimeter wire not properly setup around 
dock

Follow instructions in installation guide to align wire

Perimeter wire close to a source of interfer-
ence

Leave adequate distance between your perimeter wire 
and source of interference (approx. 1 m)

Change perimeter wire ID in the menu

Machine fails to oper-
ate

Isolator switch not turned on

Remove mower out of the dock, turn on switch and re-
place mower back in the dock (ensure dock is on  –  LED 
is solid green). Press confirm button for screen to light 
up. Enter 4 digit PIN to activate your mower

Possible clogging

Always turn isolator switch off first, then check under-
neath the mower and clear out as necessary (always 
wear protective gloves)

Battery not fully charged

Replace mower in the docking station to charge. Docking 
station must be on.

Grass too long

Mow garden to at least 40mm before using Indego.

Increase height of cut

Battery too hot/cold

Allow mower to cool/warm or move dock to area of 
shade. Mower runs when battery internal temperature is 
between 5 ° C  –  45 ° C

Perimeter wire close to a source of interfer-
ence

Leave adequate distance between your perimeter wire 
and source of interference (approx. 1 m)

Change perimeter wire ID in the menu

Mower found with 
screen off in the lawn

Issue whilst running

Press confirm button for screen to light up or place mow-
er in dock. 

Machine does not 
charge 

Battery too hot/cold

Allow mower to cool/warm or move dock to area of 
shade. Mower runs when battery internal temperature is 
between 5 ° C  –  45 ° C

Docking station not switched on 

Switch on power supply to docking station or contact 
your Bosch service centre

OBJ_BUCH-3008-003.book  Page 30  Wednesday, November 29, 2017  12:20 PM