Газонокосилки AL-KO FC 13-90.5 HD 2WD - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
EN
Translation of the original operating instructions
- 10 -
5
Operation
5.1
Start and stop
Start
1. Release parking brake
2. Set throttle to
Choke
3. Put ignition key into ignition lock
4. Turn ignition key to
Start
5. The machine is now running
6. After a short time, move throttle to
Full throttle
position
Stop
1. Set throttle to
Idle
2. Turn ignition key to
Stop
3. The machine is out of operation now
Emergency stop
•
Turn ignition key to
Stop
5.2
Normal operation
WARNING !
Risk of injuries by highly flammable
materials and heat!
Materials hitting a hot surface may result in serious burns
on the body when they inflame; e.g. hot or burning materials
such as coal.
Keep away highly flammable materials from the
machine.
Do not move the machine over any spilled fuel or similar
substances.
1. Basic setting:
•
Park machine on an even surface
•
Refill consumables
•
Set throttle to
Stop
•
Fix mounting devices as required
2. Start the machine.
•
Release parking brake
•
Set throttle to
Choke
on operating panel
•
Put ignition key into ignition lock and turn to
Start
to start
the machine
•
Let the motor run for a short time
•
Only then move throttle to
Full throttle
•
In the
Full throttle
position, accessories may be used.
Forward drive
Press the right upper part of the foot pedal downward
Backward drive
Press the right lower part of the foot pedal downward
3. Stop machine.
•
Bring machine to a stop
•
Set throttle to
Idle
•
Turn ignition key to
Stop
to put the machine out of
operation
•
Remove ignition key
5.3
Activities after use
1. Stop the motor.
2. Roughly remove dirt and sand by using a soft hand
brush.
3. Check machine condition; remedy damage to paint
coating, if any
4. The machine must be left in a clean and dry condition.
