Газонокосилки AL-KO FC 13-90.5 HD 2WD - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
EN
Translation of the original operating instructions
- 9 -
3.4
Working position and areas of risk
Working position:
On the driver's seat
Areas of risk:
•
Area of action in front of the machine
•
Area of action behind the machine
3.5
Accessories and spare parts
Original parts
Only original spare parts and original accessories may be
used.
3.6
Transport
Transport without packaging
•
Lift the front device first as appropriate
•
Stop the machine.
•
Subsequently activate the parking brake
•
Finally fix the machine by using lashing straps.
3.7
Storage (short-term)
The machine:
•
must not be stored in the open air.
•
must not be exposed to aggressive materials.
•
must be cleaned with a soft brush before being stored.
3.8
Storage (long-term)
The following recommendations will help to ensure the long-
standing functionality of your solo by AL-KO machines:
1. Ensure that fuels are prepared for long-term storage
(longer than 30 days), e.g. add fuel stabilizer.
2. Clean the machine - Important! Also clean the underfloor.
3. Renew motor oil
4. Treat spark plugs
5. Check machine for wear, repair paint damage
6. Store the FC 13-90.5 HD 2WD /4WD in a dry place.
Please refer to the attached motor operation manual for
instructions on how to care for the motor!
4
First commissioning (first inspection of the machine) after installation
Installation and first commissioning shall be performed by your authorized solo by AL-KO dealer.
4.1
Safety
Unauthorized restart
•
It is prohibited to start the machine while another person
is working on it.
Risks of non-applied protection devices
WARNING !
Danger of injuries due to missing protective
covers!
Lack of covers may cause injuries by flinging materials.
Do not open or remove any covers during operation.
Requirements at location of use
•
Only leave the machine on plane surfaces and solid
ground.
4.2
Assembly
Please refer to installation instructions in Annex before first
commissioning.
4.3
First commissioning and functional test
Prior to first commissioning, alls missing machine parts have
to be composed as indicated in the installation instruction.
Only then the following functional test shall be performed:
Machine start
1.
Fill the fuel tank
2.
Release parking brake
3.
Check motor and oil level (see Motor Operation
Manual)
4.
Set throttle to choke
5.
Start machine / turn ignition key
6.
After a short time, move throttle to FULL THROTTLE
position
7.
If no functional failures occur until then, the machine is
ready for use.
