Einhell PXC GE-LC 18 Li Kit - Инструкция по эксплуатации - Страница 30

GB

- 30 -

8.2 Maintenance

Replacing the saw chain and cutter rail

The cutter rail needs to be replaced if

• 

 the guide groove of the cutter rail is worn;

• 

 the nose sprocket in the cutter rail is dama-

ged or worn. 

Remove the adapter plate (Item 19) from the 

cutter rail as shown in Fig. 27. Now 

fi

 t the adapter 

plate to the new cutter rail. Proceed as described 

in the section “Assembly of the cutter rail and the 

saw chain”.

Checking the automatic chain lubrication

You should check the operation of the automatic 

chain lubrication system on a regular basis in or-

der to guard against overheating and the associ-

ated damage to the cutter rail and the saw chain. 

To do this, point the tip of the cutter rail towards a 

smooth surface (board, section of a cut tree) and 

allow the chainsaw to run.

If an increasing oil trace becomes evident during 

this process then the automatic chain lubrication 

system is working properly. If no clear oil trace is 

evident then please refer to the corresponding 

instructions in “Troubleshooting”. If the information 

contained there still fails to remedy the situation 

then please contact our service department or 

another similarly quali

fi

 ed workshop.

Danger! 

Do not actually touch the surface with 

the tip of the cutter rail when performing this test. 

Keep a safe distance (approx. 20 cm).

Sharpening the saw chain

E

ff

 ective working with the chainsaw is only pos-

sible if the saw chain is in good condition and 

sharp. This also reduces the risk of kickback.

The saw chain can be re-sharpened by any dea-

ler. Do not attempt to sharpen the saw chain your-

self unless you have the necessary special tools 

and experience.

8.3 Ordering replacement parts:

Please quote the following data when ordering 

replacement parts:

• 

 Type of machine

• 

 Article number of the machine

• 

 Identification number of the machine

• 

 Replacement part number of the part required

For our latest prices and information please go to 

www.isc-gmbh.info

9.  Notes on environmental 

protection / disposal

The equipment is supplied in packaging to pre-

vent it from being damaged in transit. The raw 

materials in this packaging can be reused or 

recycled. The equipment and its accessories are 

made of various types of material, such as metal 

and plastic. Never place defective equipment in 

your household refuse. The equipment should 

be taken to a suitable collection center for proper 

disposal. If you do not know the whereabouts of 

such a collection point, you should ask in your 

local council o

ffi

  ces. 

10. Storage

Store the equipment and accessories out of 

children’s reach in a dark and dry place at above 

freezing temperature. The ideal storage tempe-

rature is between 5 and 30 °C. Store the electric 

tool in its original packaging.

Anl_GE_LC_18_Li_Kit_SPK7.indb   30

Anl_GE_LC_18_Li_Kit_SPK7.indb   30

04.04.16   09:28

04.04.16   09:28