AL-KO SOLO 621 - Инструкция по эксплуатации - Страница 25

GB-8

•  Do not store the saw outdoors or in damp and moist 

areas.

•  Check all the chain saw parts, in particular the chain, 

bar and sprocket, of wear after every use.

•  Ensure that the chain tension is correct. If the chain 

is too loose, it may come off during use and lead to 
injuries. The chain must be replaced immediately if it 
is damaged. The cutting teeth must be at least 4 mm 
long.

•  Check the motor housing and power cable after every 

use for damage. If there is any sign of damage, have 
the chain saw checked by a specialised workshop.

• Check the oil level and lubrication of your chain 

saw after every use. Insuffi cient lubrication leads to 
damage to the chain, bar and motor.

•  Check how keen the chain is every time before you 

use the chain saw. A blunt chain will cause overheating 
of the motor.

•  Sharpening a saw chain requires experience and spe-

cialised knowledge. We therefore recommend to have 
sharpening carried out by a specialised workshop. 

7. In the case of technical problems

• 

The machine does not start up:

 Check whether the 

current socket is live. Check whether the power cable 
is undamaged. If neither case applies, take the chain 
saw to a specialised workshop.

• 

Chain  does not run: 

Check position of handguard 

(see ill. 7). Chain only runs if handguard brake is 
released. 

• 

Oil  does not  f ow: 

Check the oil level. Clean the oil 

fl ow openings in the bar (see also the corresponding 
hints of “Maintenance and servicing). If this is not 
successful, take the chain saw to a specialised work-
shop.

Attention:  Any  maintenance or repair work  

going beyond that described in these Operating 

Instructions  may only be carried out by autho-

rised persons or a specialised workshop.
Attention:  If the power supply lead of this 

device  shows any defects, the lead must be 

replaced by an  authorized  repair shop only or 

a  specialised workshop

,

  as this work requires 

special tools.

8. Repair Service

Repairs to electric power tools should only be carried out 
by specialist electrical personnnel.

9. Waste disposal and environmental protection

If your device should become useless somewhere in the 
future or you do not need it any longer, do not dispose 
of the device together with your domestic refuse, but 
dispose of it in an environmentally friendly manner. 
Please dispose of the device itself at an according collec-
ting/recycling point. By doing so, plastic and metal parts 
can be separated and recycled. Information concerning 
the disposal of materials and devices are available from 
your local administration.

10. Warranty 

For this electric tool, the company provides the end user 
- independently from the retailer‘s obligations

resulting from the purchasing contract - with the following 
warranties:

The warranty period is 24 months beginning from the 
hand-over of the device which has to be proved by

the original purchasing document. For commercial use 
and use for rent, the warranty period is reduced to

12 months. Wearing parts and defects caused by the use 
of not fi tting accessories, repair with parts that are

no original parts of the manufacturer, use of force, stro-
kes and breaking as well as mischievous overloading

of the motor are excluded from this warranty. Warranty 
replacement does only include defective parts,

not complete devices. Warranty repair shall exclusively 
be carried out by authorized service partners or a spe-
cialised workshop. In the case of any intervention of not 
authorized personnel, the warranty
will be held void.

EC declaration of conformity

The EC declaration of conformity on a separate piece of 
paper forms part of this original instruction.