De Dietrich DOP6557X - Инструкция по эксплуатации - Страница 10

e n g l i s h

cookware. The side grills are pyrolysis safe and may be

left inside the oven during pyrolysis.

CLEANING THE OUTER SURFACES

To clean both the electronic programmer window and the

oven door, use a window washing product applied to a soft

cloth. Do not use abrasive creams or scouring sponges.

CLEANING THE INNER SURFACES

NO PYROLYSIS OVENS

• Smooth side panel models (3.1.1).

- Clean the still-warm oven with a cloth dipped in hot, soapy

water.

•   Rough side panel, self-greasing, catalytic models  (3.2.1)

REPLACING ROUGH CATALYTIC SIDE PANELS 

The oven has an enclosure fitted with removable panels

covered with a special microporous enamel (catalytic

enamel) which gives them self-degreasing properties. As

soon as dirt appears, it spreads out and is dispersed into the

microporous holes. It is oxidised on both sides and gradually

disappears. The self-degreasing enamel is mainly suited for

fatty, rather than sugary substances. This is why the oven

floor, which is more subject to sugary overflow, is not

covered with this enamel.

We strongly recommend :

- That you do not scrub these catalytic walls with metallic

brushes, pointed or sharp instruments.

- That you do not try to clean them with commercial

scouring products.

- When grilling food, the temperature of the walls is not

always sufficient to eliminate major spattering of fat.

In this case, when you have finished cooking, leave the oven

switched on for 20 to 30 minutes at the maximum

temperature for the sequence chosen.

If traces of spatter remain, they will be reduced during

subsequent cooking operations.

It is recommended that you replace the two catalytic side

panels when their self-degreasing capability is no longer

effective.

Start by removing the wire shelf side supports – see the

“Removing wire shelf supports” section).

Remove the two old catalytic side panels and replace them

with new ones (3.2.1).

Warning

For any cleaning operation inside the oven cavity, the

oven must be switched off.

Before starting to disassemble the appliance, allow it to

cool down and ensure that it has been disconnected

from the power supply.

REMOVING THE WIRE SHELF SUPPORTS

Wire shelf supports with hooks. 

To remove them, lift up the front part of the shelf support to

disengage the front hook from its housing (3.3.1).

Then gently pull the whole of the support towards you and

lift the back to release the rear hook from its housing (3.3.2). 

Pull out the two shelf side supports.

Wire shelf supports with clip system. 

- Push down on the upper part of the shelf support to unclip

it from the central support (3.3.3). Tilt the support towards

the inside of the oven and lift gently upwards to disengage

it from the two holes at the bottom (3.3.4).

To re-fit the shelf supports after cleaning, follow the above

steps in the reverse order.

3.1

3.2

3.3