Oursson HB8060/GA - Инструкция по эксплуатации - Страница 6

6

ELEMENTS OF DESIGN, 

Рiс. C

PRODUCT SET, 

Pic. B

ORDER OF OPERATION:
1.

  Assemble the device with the desired attachment.

Installing a puree attachment (mixing 

liquids: sauces, pates, soups, 

cocktails, making mashed potatoes 

from thermally processed ingredients; 

chopping vegetables, fruits, etc.) or 

Speed switch

ON/OFF button

TURBO mode button

UTILIZATION, 

Pic. D

Before first use, 

wipe the Motor unit

   with a soft, dry 

cloth. Wash the bowl   , lid  , measuring cup  , mixer 

attachment   , puree attachment   and chopping knife   

with warm water and detergent. Wipe with soft, dry cloth. 

Before assembling or disassembling the device and/

or removing attachments, make sure that the device is 

unplugged. 

The knives are very sharp, be careful.

Motor unit .............................................................1 pc.

Puree attachment .................................................1 pc.

Mixer attachment for whipping/stirring ..................1 pc.

Bowl lid .................................................................1 pc.

Stainless steel chopping knife ..............................1 pc.

Bowl ......................................................................1 pc.

Measuring cup  .....................................................1 pc.

Instructions Manual ..............................................1 pc.

Warranty card .......................................................1 pc.

Ingredients

Volume

Speed

Time

Note

    Purée attachment

Fresh berries, fruits, 

vegetables

1250 ml

TURBO

30-45 sec Ingredients must be soft or juicy.

Boiled fruits, veg-

etables and soups

600 ml

From low to 

high

30-45 sec -

Snacks: pates, 

pastes, mousses, 

vegetable and 

mushroom caviar, 

etc.

1250 ml

From medium 

to high

30-45 sec

Сut dense ingredients (for example, 

boiled meat, fried liver, etc.) into 

pieces no more than 2x2x2 cm.

RECOMMENDATION ON PREPARATION

a mixer attachment (for mixing light 

dough, making mashed potatoes, 

whipping cream or egg proteins):

• 

Insert the attachment into the motor unit and 

turn it counterclockwise until it stops Pic. D-1. 

For the mixer attachment, first insert the mixer 

attachment into the drive, you should hear a 

click, Pic. D-4; then install it into the motor unit 

in the same way, Pic. D-5. 

• 

Dip the attachment into the bowl with the 

prepared ingredients to avoid splashing.

NOTE! 

For the best results, start mixing the 

ingredients at a low speed, then increase the 

speed.

Whip the ingredients in small portions - no more 

than 4 egg whites at a time, etc.

Installing the chopping knife (used for 

preparing baby food, minced meat, 

chopped nuts, pates, chopping onions, 

herbs, garlic, etc.):

• 

Place the chopping knife into the bowl.

• 

Add the required ingredients and close the bowl 

with the lid.

• 

Place the motor unit in the special hole on the 

bowl lid and turn it clockwise.

2.

  Plug in the device.

3.

  Select the required speed by setting its speed 

switch. The device has a smooth speed control 

(from low speed to high.) Then press and hold the 

on/off button.

4.

  You can also turn on the device by holding down the 

TURBO Mode. In this case, the device will operate at 

maximal speed all the time.

5.

  To switch off, release the TURBO Mode.

6.

  Unplug the device.

7.

  Remove the motor unit.

You can open the bowl’s lid only when the 

motor unit is removed.

Maximum time of continues use of the device 

– 1 minute. The interval between the cycles 

should be 5-10 minutes.

Before chopping, it is recommended to cut ingredients into 2x2x2 cm cubes. Chopping time and weight in the table are 

shown for information purposes only and may vary depending on the original quality and freshness of the products.