Smeg KDV907X - Инструкция по эксплуатации - Страница 21

Вытяжки Smeg KDV907X - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.

Если остались вопросы, задайте их в комментариях после инструкции.

"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Страница:
/ 52
Загружаем инструкцию
background image

 

21 

(blinking push-button) , following 
this the suction function will either 
turn off or return to the suction-
speed that had previously been 
selected.  

 

Note: 

It is possible to keep a 

check of this function so that the 
hood switches off 5 minutes after it 
has worked, (even though another 
function had been selected prior to 
this one) after having pressed the 
button, press again and keep 
pressed , the pilot-light will start 
blinking indicating that the selected 
function has been set..

 

 

6.

 

Reset Button for  saturation of 
filters: 

the hood will warn the user 

that it is time to do maintenance 
work on the filters, by giving out a 
light-signal. 

 

Red-light Button blinking:

 carry 

out the maintenance of the greasy 
filters, following this press the 
button for over 3 seconds and the 
button will turn off. 

 

Red-light Button:

 carry out 

maintenace on  carbon-filters, 
following this press the button for 
more than 3 seconds, the button 
will switch off. 

 

Attention:

 the hood is provided 

only with a warning signal for 
greasy filters. 

 

To put into function the greasy-
filter signal:: Set the cooker-hood 
off, press switch button no.6 for 
more than 3 seconds ( the switch 
will turn on red signalling  that the 
function has been set. 

  To disactivate the carbon filter 

signal, repeat the entire procedure 
again.

 

 

Maintenance 

Before performing any maintenance operation, isolate the 
hood from the electrical supply by switching off at the 
connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products.  

DO NOT USE ALCOHOL!

 

 

Grease filter 

This must be cleaned once a month (or when the filter 
saturation indication system – if envisaged on the model in 
possession – indicates this necessity)  using non aggressive 
detergents, either by hand or in the dishwasher, which must 
be set to a low temperature and a short cycle. 
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
To remove the grease filter, pull the spring release handle. 

Fig. 2 

 

Charcoal filter (filter version only) 

It absorbs unpleasant odours caused by cooking. 
The charcoal filter can be washed once every two months (or 
when the filter saturation indication system – if envisaged on 
the model in possession – indicates this necessity)   using hot 
water and a suitable detergent, or in a dishwasher at 65°C (if 
the dishwasher is used, select the full cycle function and leave 
dishes out). 
Eliminate excess water without damaging the filter, then 
remove the mattress located inside the plastic frame and put it 
in the oven for 10 minutes at 100° C to dry completely. 
Replace the mattress every 3 years and when the cloth is 
damaged. 
Remove the filter holder frame by turning the knobs (

g

) 90° 

that affix the chimney to the cooker hood. 
Insert the pad 

(i) 

of activated carbon into the frame 

(h)

 and fit 

the whole back into its housing 

(j)

Fig. 3 

It is possible to use a traditional carbon filter,  neither 
washable nor regenerable, to be  replaced every 3 - 4 months.  
The filter holder frame of the carbon filter is welded together; 
the eventual frame supplied with the hood is not, therefore, to 
be used.  
Insert it into its housing and fix it turning the 2 plastic knobs. 

 

Характеристики

Оцените статью
tehnopanorama.ru
Остались вопросы?

Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)

Задать вопрос

Часто задаваемые вопросы
Как посмотреть инструкцию к Smeg KDV907X?
Необходимо подождать полной загрузки инструкции в сером окне на данной странице
Руководство на русском языке?
Все наши руководства представлены на русском языке или схематично, поэтому вы без труда сможете разобраться с вашей моделью
Как скопировать текст из PDF?
Чтобы скопировать текст со страницы инструкции воспользуйтесь вкладкой "HTML"