Kuppersberg Slimlux II 60 XGL - Инструкция по эксплуатации - Страница 9

9

ENGLISH

TECHNICAL PASSPORT

Integrated extractor hood SLIMLUX II

7.  M A I N T E N A N C E  A N D 

C L E A N I N G 

Before carrying out any cleaning 

or maintenance activities, ensure that 
the extractor is disconnected from the 
mains. 

To carry out cleaning and 

maintenance, follow the Safety 
Instructions. 

There  is  a  fi re  risk  if  cleaning  is 

not carried out in accordance with the 
instructions. 

Filter cleaning 

To  withdraw  the  fi lters  from  their 

locations release the anchoring points. 
Clean  the  fi lter,  either  by  putting  it  in 
the dishwasher (see notes) or leaving 
it standing in hot water to simplify 
the removal of grease or, if wished, by 
means of special sprays (protecting the 
non metallic parts). Once clean, leave it 
to dry. 

Attention

: the cooker hood will 

not  work  until  the  main  fi lter  was 
reinstalled. 

Notes

: cleaning in the dishwasher 

with aggressive detergents may 
blacken the surface of metallic parts, 
without this affecting its gas retaining 
properties. 

N.B.

  The  fi lter  must  be  cleaned  at 

least once a month depending on how 
often the extractor is used. It must be 
remembered that grease is deposited in 
the extractor when cooking, whether it 
is switched on or not. 

Cleaning of the extractor body 

The use of warm (40

o

C approx.) 

soapy water is recommended. A cloth 
moistened in this water is used for 
cleaning the extractor, paying special 
attention to the grids. Afterwards, dry it 
using a lint-free cloth. 

Note: 



Never use metallic scouring pads 

or abrasive products that could damage 
the surface. 



Do not use scrapers with metallic 

surfaces such as knives, scissors etc. 

Activated charcoal fi lter 



To  install  the  charcoal  fi lter,  the 

motor anchorage is made to coincide 
with the anchor points of the activated 
charcoal fi lter and turn it clockwise. 



The  carbon  fi lter  lasts  from 

three to six months depending on the 
particular conditions of use. 



The  activated  carbon  fi lter  can 

neither be washed nor regenerated. 
Once it is exhausted, it must be changed. 



To replace exhausted fi lters with 

new ones, withdraw the old one in the 
reverse order to that of installation. 

Changing Bulbs



Firstly it is important that the 

mains are disconnected, and ensure the 
bulbs that are to be replaced are not 
hot.



Remove the light lens to expose 

the extractable lamps.



The maximum bulbs power is 4 

0W.