Jet Air Zarina Rail CRBR/A/90 - Инструкция по эксплуатации - Страница 13

13 

Note: 

Some models only possess one suction Power. 

 
Attention: the models with an electric valve are supplied with 3 
keys: 

(a) 

Light ON/OFF, 

(b) 

Electric Valve Closure and 

(c) 

Opening.  

Maintenance 

ATTENTION! 

Before performing any maintenance operation, 

isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

WARNING: 

Failure to carry out the basic cleaning 

recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  
Therefore, we recommend oserving these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Grease filter 

Fig. 9-24 
Traps cooking grease particles. 

This must be cleaned once a month (or when the filter 
saturation indication system – if envisaged on the model in 
possession – indicates this necessity)  using non aggressive 
detergents, either by hand or in the dishwasher, which must 
be set to a low temperature and a short cycle. 
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
To remove the grease filter, pull the spring release handle. 

Charcoal filter (filter version only) 

Fig. 23 
It absorbs unpleasant odours caused by cooking. 

The saturation of the activated charcoal occurs after more or 
less prolonged use, depending on the type of cooking and the 
regularity of cleaning of the grease filter. 
In any case it is necessary to replace the cartridge at least 
every four mounths. 
The carbon filter may NOT be washed or regenerated. 
Remove the grease filters. 
Fit the charcoalfilters over the motor. 
Align the 

pins R

on the cowl with the 

slots S

, then turn the 

filter clockwise until it locks in place. 
Reverse the above procedure to remove the charcoal filters. 
Refit the grease filters. 

Replacing lamps 

Fig. 25 

Disconnect the hood from the electricity. 

Warning! 

Prior to touching the light bulbs ensure they are 

cooled down. 
  

Model with halogen light bulbs.

1.

  Using a flat head screwdriver or equivalent tool, carefully 

pry loose the light cover.   

2.

  Remove the damaged light and replace with a new 

12 

Volt, 20 Watt 

(Maximum) halogen light made for a

 G-4 

base

 SUITABLE FOR USE IN OPEN LUMINAIRES.  

Follow package directions and do not touch new light 
with bare hands. 

3.

  Reinstall the light  cover. (it will snap shut). 

Model with incandescent light bulbs:

1.

  Remove the grease filters . 

2.

  Replace faulty bulbs, always using new bulbs of 

max. 40 

W (E14). 

3.

  Refit the grease filters. 

  
If the lights do not work, make sure that the lamps are fitted 
properly into their housings before you call for technical 
assistance.