GRUNDIG GDSP2460BC - Инструкция по эксплуатации - Страница 13

13

ENGLISH

INSTALLATION OF APPLIANCE _______________________

Connecting to  Chimney

1- Flap Pin Socket

2- Flap Pin

Insert the plastic pin (Figure 10 / area no. 2) 

on the pin socket on the motor exhaust (Figure 

10 / area no.1). Then bend the flap lightly to 

insert the other pin on the flap and insert the 

other pin to its socket (Figure 10).
If you are going to use the Ø 120/150 mm 
plastic  Chimney adapter, connect one end of 
the pipe to this adapter, if you are not going 
to use it, to the direct output on the product. 

Hold the cooker hood by its body and place it 

on the mounting screws on the wall and tight-

en the screws (Figure 9).

Secure the cooker hood with two 4.8x50 

screws to the wall through the mounting hole 

on the interior of the appliance (Figure 9).

Ok

Not Ok

(a)

(b)

(Figure 9)

(Figure 11)

(Figure 10)

Connect the other end of the pipe to your  
chimney. Check that these two connections 
are tight enough so they will not come out 
when the appliance runs on full power. Ensure 
that the flaps inside the  Chimney work when 
tightened with clamp. Connect the  Chimney 
connection duct outside the adapter (Figure 
11/a). If the connection duct is fitted inside 
the adapter, suction of air shall not occur as 
the Chimney flap that prevents the return of 
air will remain closed (Figure 11 / b). The 
length of the pipe connection as well as the 
number of elbows must be as minimum as 
possible.
A :  Chimney exit pipe
B :  Chimney Clamps
C: Plastic  Chimney
The valves are closed then the appliance is 
not operating and prevent possible outside 
odour and dust from entering inside.