GRUNDIG GDSP2460BC - Инструкция по эксплуатации - Страница 12

12 ENGLISH

INSTALLATION OF APPLIANCE _______________________

A

CAUTION

Before drilling, ensure that 

there are no power, gas or 

water pipes in the close 

proximity of the drilling 

locations.

Wall Mounting

• Wall must be flat, straight and have the 

sufficient bearing capacity.

• Depth of drilling holes must comply with 

the length of bolts.

• The bolts and dowels provided are 

suitable for brick walls. For other con-

struction material (e.g. drywall, plate, 

porous concrete), suitable fixing dowels 

and nuts shall be used.

Draw a mid location line from the ceiling 

perpendicular to the lower edge of the 

hood ().

Paste the installing template provided 

within the accessories on the surface 

where the hood is to be mounted. In do-

ing this operation, observe the mounting 

height of the hood (Page 12 / Figure 6). 

There is a tab in the middle of the  Chim-

ney connection plate. Place the middle 

point of this tab on the line that is drawn 

perpendicular to the wall. In doing this op-

eration, adjust the hood according to the 

maximum height (Page 8 / Figure 1). Mark 

the holes where the  Chimney connection 

plate will be mounted with the help of a 

pen (Figure 7/a).

Drill the marked points with Ø6mm drill 

and insert 2 plastic dowels in the drilled 

holes (Figure 7/a). Fix the  Chimney con-

nection plate to the wall with 3,9x22 

screws (Figure 7/a).

To assemble the hood body, you can use 

the Ø8mm drill bit to drill points A, B, C, 

D on the assembly template, and insert 

4.8x50mm plastic dowels at these points. 

(Figure 7/b).

2 piece 4.8x50 suspension screw with 

a clearance of 5 mm between the screw 

head and the wall (Figure 7/b).

1. Hanger Plate

2. Hanging Plate Connection Screw

In order to install your hood to the wall, 

loosen the screws on the hanger plates 

mounted on the motor cabin and pull them 

up, and then fasten again (Figure 8 / A).

Turn on the suction glass of the hood and 

remove the  Aluminum  aluminium grease 

filter (Page 11 / Figure 4).

(Figure 7)

(Figure 8)