Falmec Stella isola 90 ix ECP - Инструкция по эксплуатации - Страница 28

26

METALLIC FILTERS AND CARBON FILTER

H

1.   METAL FILTERS

To access the metallic filters open the AP panel (see fig. 1). To remove the grease-trapping 
metallic filter pull on the handle.

2.   CHARCOAL FILTERS

Hood not designed for charcoal filters.

LIGHTING 

ASSEMBLY AND REPLACEMENT

I

The range hood is equipped with high efficiency, low consumption LED spotlights with ex-
tremely long duration under normal use conditions. 

MAINTENANCE AND CLEANING

L

Constant maintenance ensures the correct operation and efficiency of the appliance over 
time. Special attention should be paid to the metal grease-trapping filters and the charcoal 
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do 
not accumulate on the range hood, with the consequent risk of fire.

1.  METAL GREASE-TRAPPING FILTERS

These trap the fat and grease particles suspended in the air, and therefore should be 
washed every month in hot water and detergent, without bending them. Wait until they 
are completely dry before repositioning them.  To remove and replace these filters, see 
the instructions in point H1. This operation should be performed at regular intervals. 

2.   CARBON FILTERS

Hood not set up for carbon filter.

3. CLEANING THE OUTSIDE OF THE APPLIANCE

It is advised to clean the external hood surfaces at least every 15 days in order to avoid 
that oily or greasy substances affect the steel surfaces.

The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid 
detergent or denatured alcohol. 

In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using 
clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain 
abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using 
abrasive substances or rough cloths will inevitably damage the finish of steel. The steel 
surface will be irrevocably damaged if the instructions above are not complied with.

Keep these instructions together with the instructions for use of your hood. 

The manufacturer accepts no liability for any damage caused by non-compliance with the 
instructions above. 

4.  CLEANING THE INSIDE OF THE APPLIANCE

The electrical parts or parts of the motor assembly inside the range hood must not be 
cleaned using liquids or solvents.

  Do not use abrasive products. All the above operations must be performed after having dis-

connected the appliance from the mains power supply.

English