Falmec Mirabilia Isola 67 Alphabet Vetro (800) ECP - Инструкция по эксплуатации - Страница 22

20

Phase 3

-  To prevent the hood from detaching if pressure is exerted from beneath, secure it to the wall 

with the brackets supplied (fig. O3).

-  Fit pipe/hose (E) into (D).

Phase 4

  Place extension (H) in the chimney (G) and fasten this assembly to the body of the hood 

using screws (V1).

- Slide the extension (H) until it is positioned at the desired height.
- Once you have found the best position, lean the bracket (L) on the wall, verify the horizontal 

alignment with a spirit level and mark 2 drilling points at the ends.

- Drill the holes, insert 2 expansion bolts of 4mm ø and fasten the bracket (L) with the relative 

screws.

- Tighten the extension (H) to the bracket (L) using screws (M).
- Power the hood in accordance with regulations in force (sec. D).

O2 - INSTRUCTIONS FOR MIRABILIA ISLAND 85/ISLAND 65 CENTRAL CHIMNEY
Phase 1

-  Identify the desired height for the positioning of the hood.
-  Slide the lattice-works (C) and (C1) to the desired height (H2), then block them with the 8 self-

threading screws (V2) (Fig.1a).

- Fasten the lattice-work (C) to the ceiling using the four Ø 8 expansion plugs and relative 

screws(V1) (Fig.1b).

Phase 2

-  Insert the extension on the flue and fasten them to each other with masking tape (Fig. 2).
-  Fasten the flue-extension assembly (D+E) to the lattice-work (C) with the 4 M4 metric screws 

(V3) inserted in the existing holes without tightening them completely (Fig. 2).

- For suction version: identify the optimal height for the rigid or flexible exhaust pipe (F) and 

connect it to the motor connection.

Phase 3

- Raise the hood, hooking it onto the 4 M5 metric screws (V4) pre-tightened to the lattice-work 

(C) (center the Ø11 holes on the slot of the inner liner and move it laterally)(Fig. 3a).

-  Completely tighten the 4 M5 screws (V4) (Fig. 3b).
-  Remove the masking tape (Fig. 3c), remove the four M4 metric screws (V3) previously tightened 

onto the lattice-work (Fig. 3d) and slide the flue-extension assembly downwards. (Fig. 3e).

-  Connect the pipe to the connection of the ceiling discharge hole. (Fig. 3f).
-  Make electrical connections only after having removed electrical power supply.
-  Fasten the extension to the lattice-work (C) by means of the 4 M4 metric screws (V3), without 

tightening them completely(Fig. 3g).

- Block the extension completely to the lattice-work (C) by screwing down the 4 M4 metric 

screws (V3).

-  Block the flue with the 2 self-threading screws (V5) (Fig. 3i).
-  Use the extension support elements(A) (Fig. 2) only if the upper lattice-work is not used, or in 

the case of a false ceiling.

-  Fit the glass panels (fig. O5).