Falmec Mirabilia Isola 67 Alphabet Vetro (800) ECP - Инструкция по эксплуатации - Страница 21

19

English

are completely dry before repositioning them.  To remove and replace these filters, see 
the instructions in point H1. This operation should be performed at regular intervals. 

2.   CHARCOAL FILTERS

These trap the odours present in the stream of air that passes through them. The air is puri-
fied by passing a number of times through the filters and being recirculated into the kitchen. 
The charcoal filters cannot be cleaned, and should be replaced on average every 3-4 months 
(according to use). To replace the charcoal filters, see the instructions in point H2.

3. CLEANING THE OUTSIDE OF THE APPLIANCE

It is advised to clean the external hood surfaces at least every 15 days in order to avoid that 
oily or greasy substances affect the steel surfaces.

The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid 
detergent or denatured alcohol. 

In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using 
clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain 
abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using 
abrasive substances or rough cloths will inevitably damage the finish of steel. The steel 
surface will be irrevocably damaged if the instructions above are not complied with.

Keep these instructions together with the instructions for use of your hood. 

The manufacturer accepts no liability for any damage caused by non-compliance with the 
instructions above. 

4.  CLEANING THE INSIDE OF THE APPLIANCE

The electrical parts or parts of the motor assembly inside the range hood must not be 
cleaned using liquids or solvents.

  Do not use abrasive products. All the above operations must be performed after having dis-

connected the appliance from the mains power supply.

WARRANTY

M

The new equipment is covered by warranty.

The warranty conditions are provided by the distributor.

  The manufacturer is not liable for any inaccuracies in this booklet resulting from printing or 

transcription errors. The manufacturer reserves the right to modify its products as it consid-
ers necessary or in the interests of the user, without compromising their essential safety and 
operating characteristics.

HOOD INSTALLATION

N

WARNING:

 Failure to install the screws or fixing device in accordance with these instructions 

may result in electrical hazards.

O1 - INSTRUCTIONS FOR WALL-MOUNTED MIRABILIA HOODS
Phase 1

- Place the support bar next to the wall (A-Fig. O1), at a height above the cooktop which cor-

responds to X+300 mm.

- With a spirit level check that the bar is horizontal. Mark a point at each end of the bar.
- Drill the holes, fit 2 ø8mm expansion joints and screw in the bar.

Phase 2

-  Fit the hood to the support bar (Fig. O2).
-  Adjust hood alignment with the relevant screws: The top screw (B) adjusts the distance from 

the wall. The bottom screw (C) adjusts the vertical sliding movement.