Falmec Luce 90 - Инструкция по эксплуатации - Страница 19

ENGLISH

19

24h

Speed 1 button

With LED on (speed 1 already running): 
•  Pressing this key 

will switch off the hood

 motor and the LED associated with the key 

With LED off: 
• A 

short 

press 

starts or sets the hood at speed 1 

(the function starts when the key is released); when speed 1 is running, the relative 

LED lights up.

•   With the motor off, a 

long press (at least 3 seconds)

 will start the recirculation function: in this mode (for 24 hours), the hood runs an 

operating cycle which involves starting the motor at the 1st speed for 1 hour, followed by 3 hours with the motor down. This cycle is 
repeated for 24 hours, until timeout. For these 24 hours, the LED flashes, meaning that the recirculation function is running. With this 
feature enabled, you CANNOT select other speeds. 

•  To deactivate this function, keep the relative key pressed for at least 3 seconds.

Speed 2 button

With LED on (speed 2 already running): 
•  Nothing will happen when this key is pressed. To 

switch the hood off

 firstly select speed 1, then press the "speed 1 button" again.

With the LED off and a speed on: 
•  Press the key (

long or not

) to 

set the hood on speed 2

. When speed 2 is running the relative LED will light up.

With the LED off and NO speed on: 
•  Nothing will happen when this key is pressed.

Speed 3 button

With LED on (speed 3 already running): 
•  Nothing will happen when this key is pressed. To 

switch the hood off

 firstly select speed 1, then press the "speed 1 button" again.

With the LED off and a speed on: 
•  Press the key (

long or not

) to set

 the hood on speed 3

. When speed 3 is running the relative LED will light up.

With the LED off and NO speed on: 
•  Nothing will happen when this key is pressed.

Speed 4 button

With LED on (speed 4 already running): 
•  Nothing will happen when this key is pressed. To 

switch the hood off

 firstly select speed 1, then press the "speed 1 button" again.

With the LED off and a speed on: 
•  Press the key (

long or not

) to set

 the hood on speed 4

. When speed 4 is running the relative LED will start flashing; the 4th, or inten-

sive, speed is timed and after approximately 7 minutes the motor will automatically switch to 3rd speed. 

With the LED off and NO speed on: 
•  Nothing will happen when this key is pressed.

Light Button

Light:
•  By briefly pressing the key (the back-lit button), you turn the light on and off.

LIGHTING

The hood has fluorescent lamp lighting.
If the lamp ever needs to be replaced:
• 

disconnect the appliance from the electrical mains power supply by unplugging it or turning off the main switch;

Phase 

I

 page 6

• 

remove the covering element (

N

) (Fig. 

1

 and 

2

);

•  take out the blown fluorescent tube (

M

) (Fig. 

3

 and 

4

);

•  put in a new fluorescent lamp by performing, in reverse order, the operations described in Fig. 

3

 and 

4

;

The new fluorescent lamp must be identical to the old one! 

•  put the covering element back in (

N

) performing, in reverse order, the operations described in Fig. 

1

 and 

2

;

•  connect the appliance back up to the electrical power mains.