Falmec Ghost 60 (600) P.E - Инструкция по эксплуатации - Страница 16

14

number of lights that light up on keys T3-T4-T5 indicates the fan speed level.

5: INCREASE IN FAN SPEED

By pressing this key the motor will

 pick up to the third speed.

6: - LIGHT – RADIO CONTROL ACQUISITION
Light: 

Briefly pressing key T6 will turn the light on and off. Key T6 will light up if the light is on. If 
the mobile part is closed, it will now open and the light will come on after a few seconds.

Radio control acquisition (optional): 

With the motor and light turned off, holding down key T6 will 

enable remote binding mode. Key T6 will flash for a maximum of 10 seconds.  While it is 
flashing at least one radio control key must be pressed.  The function will switch off when 
the 10 seconds are over, or earlier if a compatible remote control is detected.

MANAGING USE OF THE KEYS:
Radio control (optional): 

Place the device away from sources of electromagnetic waves which may 

interfere with the electronics of the hood. Maximum operating distance of 4 metres. This 
distance may vary based on any electromagnetic interference from other devices.  

Function of the 

remote control

DESCRIPTION

Light Key

Pressing the Light key will switch the light on/off

‘ - ‘ Key

Pressing the ‘-’ Key will decrease motor speed. If 1° (1st) speed is in gear, pressing 
the ‘-’ key will turn off the motor

‘ + ‘ Key

If the motor is turned off, pressing the ‘+’ key will activate the motor at 1° (1st) 
speed. If the motor is operating, pressing the ‘+’ key will increase motor speed up 
to the maximum.

Timer Key

If the motor is active, pressing the timer key will activate/deactivate the timer 
function

Code Change 
(only in case of 
malfunction)

Press the “Luce” (Light) key together with the “Timer” key of the remote control 
until the blue LED begins to slowly flash. If the “-” key of the remote control 
is pressed within 5 seconds, the new code will be generated and memorised. 
Memorisation is confirmed by 3 brief flashes of the LED.
To return to the default code, apply pressure on the “-” key together with the “+” 
key for over 5 seconds. Memorisation of the default code will be signalled with 3 
brief flashes of the LED.
Each time that a new code is generated or that the default code is set in the 
remote control, it is necessary to also carry out the previously described Remote 
Binding (Light Key of the pushbutton) procedure. 

FILTERS

REMOVING AND REPLACING’S INSTRUCTIONS

H

1. METAL FILTERS

To remove the metal filter, open the door, following the procedure indicated in section G 
(door opening button 1). This way, the filters can be removed by acting on the appropriate 
handle.

2. CARBON FILTERS

Remove the metal filters as indicated in section H1. This way the carbon filters can be acces-

sed and be removed easily.

ONLY FOR ITALY:

 Download the filter order module from the website:

www.falmec.com (access the drop-down assistance menu).