Вытяжки Falmec Flipper 85 ix (800) ECP - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
15
English
Pushbutton +
Press to increase motor speed
Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the
timer LEDs).
(In the 4-speed version the pushbutton + blinks. The fourth speed remains on for a set duration
of time. After 15 minutes the motor returns to the third speed).
Mode pushbutton
Function: it turns hood motor on and off.
The function
“desired speed”
enables to start the motor at the speed that was selected before
the hood was last turned off.
Optional:
version with remote control (some versions only).
WARNING:
Install the hood away from sources of electromagnetic waves, as these could affect the cor-
rect operation of the electronic system.
Maximum operating distance: 5 metres. The maximum operating distance could be less than
5 metres in case of electromagnetic interference by other equipment.
Light pushbutton on remote control: light on/off.
– and + pushbutton: increase/decrease speed (to start the motor press either the + or the –
pushbutton).
Timer pushbutton: see instructions below.
Timer and ‘filter clogged’ alarm pushbutton
• This function allows the automatic turning off of the hood after running for 15 minutes at the
speed previously set (the pushbutton shows a flickering light).
• After about 30 hours of running the pushbutton indicates the need for washing the metal
filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton
for a few seconds until the red light turns off. Then turn the hood off and on again to check
that the alarm has disappeared.
FILTERS
REMOVING AND REPLACING’S INSTRUCTIONS
H
1. METAL FILTERS
To remove the metal grease filter, open the door carefully as shown in fig. 2. Use the
handle to remove the metal filters.
2. CHARCOAL FILTERS
Remove the metal filters by following the instructions in section H1.
The two filters attached to the right and left hand side of the conveyor can now be easily
accessed. See figure for assembly/replacement.
To order new carbon filters contact your distributor/dealer.
ONLY FOR ITALY: Download the form to order the filter from the website:
www.falmec.com (via the dropdown assistance menu).
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
