Falmec Altair 90 ix (1000) ECP - Инструкция по эксплуатации - Страница 26

24

SAFETY WARNINGS

M

  The electrical system features an earth connection in compliance with interna-

tional safety standards; furthermore, it is compliant with the European standard 
for electromagnetic compatibility. 

Do not connect the appliance to flues (from boilers, fireplaces, etc.). Make sure 
the mains voltage corresponds to the values on the rating plate located inside 
the range hood. The minimum safety distance between the cooktop and the 
range hood must be at least 65 cm. 

Never cook on “open” flames under the range hood. 

Check deep-fryers during use: superheated oil may be flammable. 
- Ensure there is adequate ventilation of the room when the rangehood is used 

at the same time as appliances burning gas or other fuels.

- Do not flambe under the rangehood
- The exhaust air must not be discharged into a flue which is used for exhaust-

ing fumes from appliances burning gas or other fuels.

- Ensure that all regulations concerning the discharge of exhaust air have been 

fulfilled before you use the appliance. 

  Before performing any cleaning or maintenance operations, disconnect the 

appliance by unplugging it or using the main switch. The manufacturer dis-
claims all liability for any damage that may be directly or indirectly caused 
to people, things and animals due to the failure to follow all the instructions 
provided in this booklet and above all the warnings relating to the installa-
tion, operation and maintenance of the appliance.

WARRANTY

N

The new equipment is covered by warranty.

The warranty conditions are provided by the distributor.

  The manufacturer is not liable for any inaccuracies in this booklet resulting 

from printing or transcription errors. The manufacturer reserves the right to 
modify its products as it considers necessary or in the interests of the user, 
without compromising their essential safety and operating characteristics.

HOODS MOUNTING INSTRUCTIONS

O

ALTAIR WALL HOOD ASSEMBLY

Phase 1 

- Place on the wall support bar (A) (Fig. 1), at the same height of the cooker  

resulting from the sum of the heights X + 260 mm. 

- With a spirit level, verify the horizontal alignment and mark two drilling 

points at the edges of bar n. 2. 

- Drill, insert n. 2 expansion bolts of 8 mm Ø and fasten the bar with the rela-

tive screws. 

Phase 2 

- Hook the hood on the support bar. 
- Adjust the alignment of the hood, using the fixing screws (Fig. 2): these can 

be reached by opening panel (D) and removing anti-grease metal filters (E).