Elica TOP SENSE IXBL/F/120 - Инструкция по эксплуатации - Страница 22

22 

Operation 

Use the high suction speed in cases of concentrated kitchen 
vapours.  It is recommended that the cooker hood suction is 
switched on for 5 minutes prior to cooking and to leave in 
operation during cooking and for another 15 minutes 
approximately after terminating cooking.  
For certain models, a remote control is available as accessory 
kit, by which you can control the main functions of the hood.  
Check with your authorised dealer or technical assistance 
centre the compatibility/suitability of your model.  
  

Control panel with 7 buttons 

To select the functions of the hood you simply touch the 
controls.  

Automatic operation (sensor) and 
connection with SNAP

® 

and Elica hob 

(See related section) 

Button ON/OFF lighting 

Press briefly to switch on or off the lighting of 
the hob. Press and hold to switch on or off 
the room lighting (only on certain models).  
 

Button for intensive speed 

(suction power)

selection

 – it lasts 5 minutes then it returns 

to medium speed (suction power) or it 
switches off if the delayed shutdown of the 
hood is activated (only with remote control). 
The button flashes in both cases to indicate 
speed timing.  

Button for high speed 

(suction power)

selection. 

The button flashes if the delayed shutdown 
of the hood is activated (only with remote 
control). 

Button for medium speed 

(suction power)

selection 

The button flashes if the delayed shutdown 
of the hood is activated (only with remote 
control). 

Button for low speed 

(suction power) 

selection

 – when flashing, it indicates that 

you must wash the grease filter.  
The button flashes if the delayed shutdown 
of the hood is activated (only with remote 
control). 

Button OFF motor

 (stand by) 

Indicators of Filter Saturation 

At regular time intervals, the hood signals the need to perform 
filter maintenance.  

 Button 

 on with steady light: perform grease filter 

maintenance. 

 Button 

 flashing: perform activated charcoal filter 

maintenance.  

 
 Note: 

Filter saturation signal is visible within the first 

minute after switching off the hood; within this time, the 
reset of saturation indicators must be performed.  

Reset of filter saturation indicators: 

Press and hold the button 

Activation of saturation indicator activated charcoal 
filter  

 Note:

 this operation must be performed with the hood off.  

This indicator is normally deactivated; press and hold the 

button 

 to activate the function: the button lights 

up with steady light.  

To deactivate the function, press and hold the button 

 : the button lights up flashing.  

Automatic operation (sensor), connection with SNAP

® 

and Elica hob 

Attention!

 The proper operation of the hood will depend on 

the ’

Setting of parameters for Automatic Operation’ 

(see 

dedicated section) 

Note: 

Automatic operation with the hob is only possible with 

specific hobs. For further details, please contact the official 
dealer or authorised technical assistance centre. 
 

Automatic operation (sensor) 

Press the button 

.

(the central LED  

"c"

 lights up in 

white 

). 

The hood will switch on at the most suitable speed based on 
the cooking fumes detected by the sensor on the hood.  
 

Automatic operation of the hood with SNAP

® 

Press the button

.

(the LEDs 

"a"

-

"b"

  light up in orange 

) to indicate that the hood can operate automatically 

with the 

SNAP

®