Вытяжки Elica NUAGE SENSE DRYWALL/F/75 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
22
Operation
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched
on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating
cooking.
The hood has an on-board controller which can also be used with the specific remote control (only supplied on some models)
Control panel on hood
T1.
Suction speed (power) control key.
Press repeatedly until the desired speed is selected, choosing
between:
Speed
OFF
– LED
L1
: off
Speed
1
(low suction) – LED
L1
:
green
light
Speed
2
(medium suction) – LED
L1
:
yellow
light
Speed
3
(high suction) – LED
L1
:
light blue
light
Speed
4
(intensive suction) – LED
L1
:
light blue button
Note:
Speed
4
has a limited duration of 5 min., and then the hood
passes automatically to speed
2
.
T2.
Light control key (hob light-dim light)
Press briefly to light up the hob
Keep it pressed longer to light up the dim light
Note:
The dim light is only available on some models.
Grease filter saturation warning - LED L1: red light
The warning is visible for about one minute after switching the hood off.
When this warning appears, the grease filter
requires
maintenance.
Charcoal filter saturation warning - LED L1: red light
The warning is available for about one minute after switching the hood
off.
When this warning appears, the charcoal filter
requires
maintenance.
Deactivation/activation of charcoal filter saturation warning:
This warning is normally activated, to deactivate it:
with the hood off, press the keys
T1
and
T2
simultaneously for
more than 5 seconds.
LED
L1
lights up red (signal on) and then begins to flash (signal
off).
Repeat the operation if you want to reactivate the signal. LED
L1
will switch from flashing red (signal off) to remaining lit (signal on).
Filter saturation warning reset
With the hood off, press the keys
T1
and
T2
simultaneously for at least
5 seconds. The LED
L1
will stop signalling saturation.
Repeat the operation in case of simultaneous warnings of both filters.
Pairing the remote control
Once the remote control has been successfully paired both LEDs light
up in several colours in sequence.
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
