Elica NUAGE SENSE DRYWALL/F/75 - Инструкция по эксплуатации - Страница 21

21 

Attention! Before connecting the hood to the electrical 
mains.

If you have an 

Elica

 hob:

Perform the electrical connections of the hood and Elica 
hob 

at the same time

 to ensure the logical connection 

between the hob and Elica hob (also refer to the 
paragraph "

Operation-Adjusting the parameters for 

automatic operation-Sensor calibration

" e "

Operation-

Adjusting the parameters for automatic operation-
Logical connection between hood and Elica hob

"). 

If you do 

NOT

 have an 

Elica

 hob: 

In this case, after being connected to the mains, the hood 
will try connecting to a hob. 

Wait for the hob to complete the connection attempts 
(approximately 5 minutes) and then disable the electronic 
connection module as follows: 

With the hob switched off, simultaneously press and hold 
keys 

T1

 and 

T2

 for 10 seconds, (see Operation 

paragraph), the hood at first emits a short sound signal 
(beep- after approximately 5 seconds), followed by a long 
sound signal (beeeep), indicating that the disabling 
process is complete (LED 

L1

 turns red for a few 

seconds). 

Reactivating the connection module between the 
hood and Elica hob: 

With the hob switched off, 

simultaneously press and hold keys 

T1

 and 

T2

 for 10 

seconds, (see Operation paragraph), the hood at first 
emits a short sound signal (beep- after approximately 5 
seconds), followed by a long sound signal (beeeep), 
indicating that the activation process is complete (LED 

L1

turns red for a few seconds). 

Expansion wall plugs are provided to secure the hood to most 
types of walls/ceilings. However, a qualified technician must 
verify suitability of the materials in accordance with the type of 
wall/ceiling. The wall/ceiling must be strong enough to take 
the weight of the hood. 

Do not tile, grout or silicone this 

appliance to the wall. Surface mounting only.