Elica GRACE BL/F/51 - Инструкция по эксплуатации - Страница 21

21 

 
Resetting the anti-fat filter saturation signal (GREEN LED 
FLASHING on the control bar)  
First proceed with the maintenance of the filter as 
described in the corresponding paragraph.   

Press the “+” and “-” keys contemporaneously for about 3 
seconds. The LED stops flashing, indicating that the resetting 
of the signal has been accomplished.  
 

Resetting the carbon filter saturation signal (ORANGE 
(amber) LED FLASHING) 
Note!

 The reset of the carbon filter saturation signal is 

normally deactivated. To activate it, see under paragraph 
“Activating the carbon filter saturation signal”. 

First proceed with the maintenance of the filter as 
described in the corresponding paragraph.   

Press the “+” and “-” keys contemporaneously for about 3 
seconds. The LED stops flashing, indicating that the resetting 
of the signal has been accomplished.  
 

Deactivating the carbon filter saturation signal (for 
special applications)

Switch the hood off (see paragraph above “Selecting the 
suction speed (power)”). 
Press the "

◄

" key or the "

►

" key until seeing the symbol 

relating to the  “Resetting and configuration of the filters 
saturation signal” function on the remote control. 
Press keys “+” and “-” contemporaneously for about 3 
seconds. The LED flashes in GREEN to indicate that the 
carbon filter saturation signal has been deactivated. 
To reactivate the carbon filter saturation signal, repeat the 
operation. The LED flashes in ORANGE. 

Maintenance of the remote control

Cleaning the remote control:  

Clean the remote control with a damp cloth and a neutral 
solution of detergent without abrasive substances. 
 

Changing the battery:   

• 

Open the battery casing using a small screwdriver with a 
flat point.  

• 

Change the finished battery with a new one of 12 V type 
MN21/23 

In inserting the new battery respect the polarity indicated 
on the battery casing!  

• 

Close the battery casing up again.  

Disposal of the batteries 

Ultimate disposal of the batteries should be handled according 
to all national laws and regulations. Do not place used 
batteries in your regular waste. 
Ultimate disposal of the batteries must be done safely

.

Contact your local waste management officials for other 
information regarding the environmentally sound collection, 
recycling, and disposal of the batteries. 

Maintenance 

Before performing any maintenance operation, isolate the 
hood from the electrical supply by switching off at the 
connector and removing the connector fuse.  

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

WARNING: 

Failure to carry out the basic cleaning 

recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  
Therefore, we recommend oserving these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Grease filter 

Fig. 22 
Traps cooking grease particles. 

This must be cleaned once a month (or when the filter 
saturation indication system – if envisaged on the model in 
possession – indicates this necessity)  using non aggressive 
detergents, either by hand or in the dishwasher, which must 
be set to a low temperature and a short cycle. 
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 

Charcoal filter (filter version only) 

Fig. 22 
It absorbs unpleasant odours caused by cooking. 

The charcoal filter can be washed once every two months (or 
when the filter saturation indication system – if envisaged on 
the model in possession – indicates this necessity)   using hot 
water and a suitable detergent, or in a dishwasher at 65°C (if 
the dishwasher is used, select the full cycle function and leave 

dishes out). 
Eliminate excess water without damaging the filter, then put it 
in the oven for 10 minutes at 100° C to dry completely. 
Replace the mattress every 3 years and when the cloth is 
damaged. 

Replacing lamps 

Disconnect the hood from the electricity. 

Warning! 

Prior to touching the light bulbs ensure they are 

cooled down. 

To replace the central lamp: 

use only 40W max 40° D25 

GU10.halogen lamps. 

Removing the bulb:  

rotate anti-clockwise a quarter turn and take out.   

Mounting the bulb:  

insert the bulb in its seat so that its contacts enter the 
congruent  seats on the bulb-holder, rotate clockwise for about 
a quarter turn. 

Some models envisage lateral lamps: