Timberk SWH SE1 30 VO - Инструкция по эксплуатации - Страница 8

www.timberk.com • electrical storage water heater

8

IMPORTANT! 

To guarantee reliable operation and safe use of the 

water heater check prior to the first run if it is properly 

connected to the 220V AC electrical main. The water 

heater to be connected must be securely wired up to 

the earth loop of your electrical main. 

IMPORTANT! 

Power outlet must be designed for rated current of 

10A at least; copper-conductor power cord must be 

at least 3x1.5 mm2 in cross-section (for copper).

IMPORTANT! 

Water can drip from the pressure safety valve upon 

heating. IT IS IMPOSSIBLE TO AVOID DRIPPING 

AND IT IS FORBIDDEN TO PREVENT IT BECAUSE 

IT CAN RESULT IN TANK RUPTURE (IN THE CASE 

OF EQUIPMENT FAILURE). Working ability of the 

pressure safety valve should be inspected every 

14 days. The inspection method is described in the 

section 9 (MAINTENANCE).

8. HOW TO CONTROL WATER HEATER 

OPERATIONS

Control panel (fig. 8)

Control panel (fig. 8)

Fig. 8

1. Thermostate handle
2. «HEATING» indicator lamp

9. WATER HEATER CONTROL

10. MAINTENANCE

1. At first, open one of the outlet valves on the outlet of the water heater; 

then open the inlet valve. The electric water heater will start filling in with 

water. When water flows from the outlet valve freely it means that the water 

heater is fully filled with water, and you can close the outlet valve.
Warning: During normal operation the inlet valve must be set open.
2. Plug the power cord into the outlet, after this the handle light will be on. 

1. Check the power plug and outlet as often as possible. Secure electrical 

contact and proper grounding must be granted. The plug and outlet must 

not heat excessively.
2. If the water heater is not used for a long time, especially in regions with 

3. Set the desired temperature of water by the temperature controller 

handle by rotating the handle; “HEATING” indicator lamp (fig. 8) will flash 

on. When water reaches the preset temperature “HEATING” indicator lamp 

will go out. When water temperature drops to a certain level heating will 

be switched on automatically and restore the required water temperature.
4. After rotating the handle to the position «MIN» the minimum temperature 

+30°C (± 5°C) would be seted. After puting the handle in to position «MAX», 

the maximum temperature would be set +70°C (± 5°C).
5. There is a “COMFORT” sign on the panel. It signifies optimal temperature 

of heating. Fixing the temperature controller handle in position “COMFORT” 

you choose the most efficient mode of electricity consumption.
6. To turn off the water heater set the switch handle to position «   » and 

unplug the power cord.